Edge Pressures Obtained Using FEM and Half-Space: A Study of Truncated Contact Ellipses
Open Access
- 1 June 2022
- journal article
- research article
- Published by MDPI AG in Lubricants
- Vol. 10 (6) , 107
Abstract
In rolling or gear contacts, truncation of the contact ellipse can occur, for example, when an undercut extends into the contact area. For an elastic calculation approach, the edge constitutes a mathematical singularity, which is revealed by a theoretically infinitely high pressure peak. However, when elastic–plastic material behavior is taken into account, the pressure peak is limited by local hardening and yielding of the material, leading to plastic deformations. As a result, those calculations are rather challenging and the results partly unexpected due to the discontinuity contained in the geometry. Nevertheless, to the authors’ knowledge, hardly any published studies exist on elastic–plastic simulations of truncated contact ellipses. Therefore, a numerical study concerning the contact of a rigid ball with an elastic–plastic plane is presented. Due to an undercut in the plane, a quarter of the theoretical Hertzian contact ellipse is cut off. The aim of the study is to investigate the influence of the undercut angle on the pressure distribution and the elastic and plastic deformation at the edge. The use of FEM shows that the undercut angle has a significant effect on the characteristics of the contact. The results obtained using FEM are then used as a reference for comparison with a semi-analytical method (SAM). It is shown that the SAM, based on the half-space, provides comparable results only for very small undercut angles.Keywords
Funding Information
- Schaeffler Technologies AG & Co. KG
This publication has 26 references indexed in Scilit:
- A Fast Correction for Elastic Quarter-Space Applied to 3D Modeling of Edge Contact ProblemsJournal of Tribology, 2011
- Three-Dimensional Repeated Elasto-Plastic Point Contacts, Rolling, and SlidingJournal of Applied Mechanics, 2008
- A universal integration algorithm for rate-dependent elastoplasticityComputers & Structures, 1996
- A SIMPLIFIED ANALYSIS FOR AN ELASTIC QUARTER-SPACEQuarterly Journal of Mechanics and Applied Mathematics, 1990
- STRESS ANALYSIS AND CONTACT PROBLEMS FOR AN ELASTIC QUARTER-PLANEQuarterly Journal of Mechanics and Applied Mathematics, 1989
- On the Stress Field and Surface Deformation in a Half Space With a Cuboidal Zone in Which Initial Strains Are UniformJournal of Applied Mechanics, 1978
- On the Stress Field Due to Initial Strains in a Cuboid Surrounded by an Infinite Elastic SpaceJournal of Applied Mechanics, 1977
- The elasto‐plastic indentation of a half‐space by a rigid sphereInternational Journal for Numerical Methods in Engineering, 1971
- A General Solution for the Elastic Quarter SpaceJournal of Applied Mechanics, 1970
- Ueber die Berührung fester elastischer Körper.Journal für die reine und angewandte Mathematik (Crelles Journal), 1882