Effects of dead loads on the lateral response of battered pile groups
Authors:
- L M ZhangLZL M Zhang
- M C McVayMMM C McVay
- S J HanSHS J Han
- P W LaiPLP W Lai
- R GardnerRGR Gardner
- 1 June 2002
- journal article
- Published by Canadian Science Publishing in Canadian Geotechnical Journal
- Vol. 39 (3) , 561-575
Abstract
The effects of vertical load on the lateral resistance of single piles were initially reviewed to facilitate the interpretation of the test results of pile groups. Then, 18 different lateral load tests were carried out in the centrifuge on the 3 × 3 and the 4 × 4 fixed-head battered pile groups to investigate the effects of vertical load on the group lateral resistance. Vertical dead loads ranging from approximately 20 to 80% of the vertical ultimate group capacity Puv were applied. Based on these tests, the effects of vertical dead load on the lateral resistance of the battered pile groups are found to depend on pile arrangement, pile inclination, and soil density. The lateral resistances of the 3 × 3 pile groups do not appear to vary considerably with the vertical dead loads in the range of the vertical loads studied. For the 4 × 4 pile groups however, the lateral resistances at vertical loads of approximately 50 and 80% Puv may be 26-29% and even 40% higher than that at the 20% Puv dead load. It may be inferred that designs based on standard lateral load tests with small vertical dead loads would be on the safe side. Three mechanisms for vertical load effects are discussed in terms of axial tension and compression failures, influence of pile inclination, and initial subgrade reaction caused by vertical loading. Preliminary numerical analyses are also performed to simulate the responses of some of the battered pile groups.Key words: pile group, battered pile, lateral resistance, load test, pile-soil interaction, centrifuge test.Keywords
This publication has 15 references indexed in Scilit:
- Centrifuge Testing of Large Laterally Loaded Pile Groups in SandsJournal of Geotechnical and Geoenvironmental Engineering, 1998
- Lateral Load Behavior of Full-Scale Pile Group in ClayJournal of Geotechnical and Geoenvironmental Engineering, 1998
- Evaluation of Laterally Loaded Pile Group at Roosevelt BridgeJournal of Geotechnical and Geoenvironmental Engineering, 1997
- Centrifuge Testing of Fixed-Head Laterally Loaded Battered and Plumb Pile Groups in SandGeotechnical Testing Journal, 1996
- Bearing capacity of flexible batter piles under eccentric and inclined, loads in layered soilCanadian Geotechnical Journal, 1994
- Interaction of Axial and Lateral Pile ResponsesJournal of Geotechnical Engineering, 1993
- Lateral Load Behavior of Pile Group in SandJournal of Geotechnical Engineering, 1988
- Cyclic Lateral Loading of a Large‐Scale Pile GroupJournal of Geotechnical Engineering, 1987
- Pile capacity for eccentric inclined load in clayCanadian Geotechnical Journal, 1984
- Ultimate Pile Capacity for Eccentric Inclined LoadJournal of Geotechnical Engineering, 1983