A transfer cell for ultrahigh vacuum surface analysis of samples exposed to electrochemical environments
Open Access
- 1 March 2026
- journal article
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 97 (3)
Abstract
We present the design and implementation of a portable transfer system equipped with an integrated electrochemical cell that enables the controlled transfer of samples between an electrochemical environment and an ultrahigh vacuum (UHV) system without air exposure. This setup allows for the preparation of well-defined model surfaces, their electrochemical modification, and subsequent structural and chemical characterization using surface-sensitive UHV techniques. The system’s performance was validated using Au(111) as a model electrode. Cyclic voltammetry performed in a hanging meniscus configuration reproduced the characteristic oxidation and reduction features of Au(111), while scanning tunneling microscopy, low-energy electron diffraction, and Auger electron spectroscopy confirmed the structural and chemical integrity of the surface after transfer. Progressive surface roughening with increasing numbers of oxidation–reduction cycles followed an approximately linear trend, consistent with previous studies. In addition, we investigated the stability of gold oxide under vacuum and demonstrated that the thin oxide formed during anodic polarization, prior to the onset of the oxygen evolution reaction, is partially reduced during UHV transfer. X-ray photoelectron spectroscopy and Auger spectroscopy data indicate that the oxidized phase is stable in vacuum only after polarization at sufficiently high potentials, when continuous oxygen evolution is achieved via water electrolysis. Finally, successful integration and testing of the system at the FlexPES beamline at MAX IV confirmed its compatibility with synchrotron-based spectroscopy.Keywords
Funding Information
- Carl Tryggers Stiftelse för Vetenskaplig Forskning (CTS21:1203)
- Vetenskapsrådet (2020-06154)
- Vetenskapsrådet (2022-03041)
This publication has 42 references indexed in Scilit:
- Probing the electrode-liquid interface using operando total-reflection X-ray absorption spectroscopySurface Science, 2024
- Acidic Oxygen Evolution Reaction: Fundamental Understanding and Electrocatalysts DesignChemSusChem, 2024
- On the Possibilities and Considerations of Interfacing Ultra‐High Vacuum Equipment with an Electrochemical SetupChemphyschem, 2019
- Electrocatalysts for the generation of hydrogen, oxygen and synthesis gasProgress in Energy and Combustion Science, 2017
- Electro-oxidation of Au(111) in contact with aqueous electrolytes: New insight from in situ vibration spectroscopyElectrochimica Acta, 2013
- Thirty years of platinum single crystal electrochemistryJournal of Solid State Electrochemistry, 2011
- Cyclic voltammetry at gold single-crystal surfaces. Part 1. Behaviour at low-index facesJournal of Electroanalytical Chemistry, 1996
- In situ electrochemical STM imaging of roughened gold and platinum electrode surfacesSurface Science, 1995
- The role of anion on the electrochemical behaviour of a {111} platinum surface; an unusual splitting of the voltammogram in the hydrogen regionJournal of Electroanalytical Chemistry and Interfacial Electrochemistry, 1980
- Preparation of monocrystalline Pt microelectrodes and electrochemical study of the plane surfaces cut in the direction of the {111} and {110} planesJournal of Electroanalytical Chemistry and Interfacial Electrochemistry, 1980