Effect of Process Parameters on the Surface Microgeometry of a Ti6Al4V Alloy Manufactured by Laser Powder Bed Fusion: 3D vs. 2D Characterization
Open Access
Abstract
The influence of the main process parameters, laser power, point distance and time exposure, on the surface microgeometry of Ti6Al4V specimens produced by a pulsed powder bed fusion process was investigated. A 3D characterization was carried out and collected data were elaborated to reconstruct the surface and to determine both the 3D and the 2D material ratio curves along different directions. The 3D material ratio curve gives a slightly lower material ratio of peak zone Mr1 and higher material ratio of valley zone Mr2, reduced peak height Rpk and reduced valley height Rvk than the 2D curves. Roughness is greater in the 3D analysis than in the 2D one, skewness is the same and kurtosis increases from 3 in 3D. Roughness and skewness increase on increasing point distance and decreasing time exposure and laser power. Within the investigated ranges (27.3–71.2 J/mm3), an increase in energy density reduces the surface roughness while skewness and kurtosis are not significantly affected. The results indicate that a 3D approach allows better characterization of the surface microgeometry than a 2D one.Keywords
This publication has 24 references indexed in Scilit:
- Surface texture metrology for metal additive manufacturing: a reviewPrecision Engineering, 2016
- Denudation of metal powder layers in laser powder bed fusion processesActa Materialia, 2016
- Fatigue characterization of Titanium Ti-6Al-4V samples produced by Additive ManufacturingProcedia Structural Integrity, 2016
- Analysis and optimisation of vertical surface roughness in micro selective laser meltingSurface Topography: Metrology and Properties, 2015
- The influence of heat accumulation on the surface roughness in powder-bed additive manufacturingSurface Topography: Metrology and Properties, 2015
- Evaluation of the Surface Roughness of Additive Manufacturing Parts Based on the Modelling of Cusp GeometryIFAC-PapersOnLine, 2015
- High Cycle Fatigue (HCF) Performance of Ti-6Al-4V Alloy Processed by Selective Laser MeltingAdvanced Materials Research, 2013
- Influence of the particle size distribution on surface quality and mechanical properties in AM steel partsRapid Prototyping Journal, 2011
- Balling phenomena in direct laser sintering of stainless steel powder: Metallurgical mechanisms and control methodsMaterials & Design (1980-2015), 2009
- Parametric analysis of the selective laser melting processApplied Surface Science, 2007