Effect of Minor P and C Regulation on Microstructure Evolution and High-Temperature Properties of Selective Laser Melted GH4169 Superalloy
Open Access
- 15 September 2026
- Vol. 19 (18) , 3910
Abstract
Selective laser melting (SLM) produces elemental segregation and nonequilibrium secondary phases in GH4169 superalloys, but the effects of P and C variations on grain-boundary phase evolution and high-temperature tensile behavior remain unclear. Alloys with primarily varied P (0.034–0.058 wt.%) and C (0.009–0.066 wt.%) contents were fabricated and heat treated identically. Microstructures were characterized by scanning electron microscopy (SEM), electron backscatter diffraction (EBSD), and transmission electron microscopy (TEM), and tensile properties were evaluated at 650 °C. The as-built alloys exhibited columnar grains, cellular substructures, cell-wall segregation, and Nb-rich Laves-phase particles. After heat treatment, cellular substructures largely disappeared, γ″ precipitates formed in the γ matrix, and fine Ti/Al-rich particles were tentatively attributed to γ′; δ phase, residual Laves phase, and MC-type carbides were present at grain boundaries. Increasing P reduced the δ-phase area fraction from 2.20% to 1.38% and changed its distribution from continuous chains to semi-continuous and discrete arrangements. Increasing C raised the MC-type carbide area fraction from 0.34% to 1.48% while decreasing the δ-phase area fraction from 1.68% to 0.98%, accompanied by carbide coarsening. The 0.050P alloy exhibited the highest yield and ultimate tensile strengths, whereas the 0.009C alloy showed the best strength–ductility balance. These results reveal distinct P- and C-related changes in grain-boundary phase evolution and tensile behavior at 650 °C.Keywords
This publication has 33 references indexed in Scilit:
- Dissolution of the Laves phase and δ-precipitate formation mechanism in additively manufactured Inconel 718 during post printing heat treatmentsAdditive Manufacturing, 2024
- Effects of Heat Treatment and Carbon Element Invasion on Microstructure and Mechanical Properties of Inconel 718 Alloys Fabricated by Selective Laser MeltingJournal of Materials Engineering and Performance, 2023
- The formation and dissolution mechanisms of Laves phase in Inconel 718 fabricated by selective laser melting compared to directed energy deposition and castComposites Part B: Engineering, 2022
- Influence of reduced carbon content on microstructure and mechanical behavior of Inconel 718 prepared by laser powder bed fusionAdditive Manufacturing Letters, 2022
- Microstructural Development in Inconel 718 Nickel-Based Superalloy Additively Manufactured by Laser Powder Bed FusionMetallography, Microstructure, and Analysis, 2022
- Effect of post-processes on the microstructure and mechanical properties of laser powder bed fused IN718 superalloyAdditive Manufacturing, 2021
- Effect of heat treatment on the microstructural evolution of a nickel-based superalloy additive-manufactured by laser powder bed fusionActa Materialia, 2018
- Microstructures and mechanical behavior of Inconel 718 fabricated by selective laser meltingActa Materialia, 2012
- The microstructure and mechanical properties of deposited-IN718 by selective laser meltingJournal of Alloys and Compounds, 2012
- Morphology of y’ and y” precipitates and thermal stability of inconel 718 type alloysMetallurgical Transactions, 1973