Deep Etching of LiNbO3 Using Inductively Coupled Plasma in SF6-Based Gas Mixture
- 3 December 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 30 (1) , 90-95
Abstract
This work is an extensive study of the plasma chemical etching (PCE) process of single-crystalline lithium niobate (LiNbO₃) in the SF₆/O₂ based inductively coupled plasma (ICP). The influence of the main technological parameters of the LiNbO₃ PCE process, including the distance between the sample and the lower edge of the discharge chamber, as well as the temperature of the substrate holder on the etching process rate, has been studied. It was shown that changing the temperature of the substrate holder in the range from 100 to 200°C, leads to a gradual rise of the etching rate from 127 to 282 nm/min. A further increase in the temperature to 250°C, results in a sharp increase in the etching rate to 711 nm/min. The maximum achieved etching rate in experimental series which were aimed at determining the dependence of the LiNbO₃ etching rate on the temperature of the substrate holder was 812 nm/min at a substrate holder temperature of 325°C. With the help of X-ray photoelectron spectroscopy (XPS) technique was found and shown that during the etching process in fluorinated plasma the nonvolatile LiF compound is formed on the surface of the treated LiNbO₃. On the basis of the obtained results, the optimal process of deep ( > 80 μm) LiNbO₃ PCE was developed, with an etched wall inclination angle of ≈ 110°, with selectivity ratio to Cr mask of ≈ 20, and an etching rate of about 300 nm/min. [2020-0317]Keywords
Funding Information
- Russian Foundation for Basic Research (19-32-60023)
This publication has 40 references indexed in Scilit:
- Lithium niobate on insulator (LNOI) for micro‐photonic devicesLaser & Photonics Reviews, 2012
- High aspect ratio lithium niobate ridge waveguides fabricated by optical grade dicingJournal of Physics D: Applied Physics, 2011
- Highly selective electroplated nickel mask for lithium niobate dry etchingJournal of Applied Physics, 2009
- Integrated Optical Devices in Lithium NiobateOptics and Photonics News, 2008
- Measurement of the thermal expansion coefficients of ferroelectric crystals by a moiré interferometerOptics Communications, 2007
- Ridge structure etching of LiNbO3 crystal for optical waveguide applicationsOptical Materials, 2005
- A Novel Wet-Etching Method Using Electric-Field-Assisted Proton Exchange in LiNbO$_3$Journal of Lightwave Technology, 2004
- Etching characteristics of LiNbO3 crystal by fluorine gas plasma reactive ion etchingSurface and Coatings Technology, 2003
- Challenges in electron cyclotron resonance plasma etching of LiNbO3 surface for fabrication of ridge optical waveguidesJournal of Vacuum Science & Technology A, 1998
- Mask erosion during dry etching of deep features in III-V semiconductor structuresSemiconductor Science and Technology, 1992