V-Spline Design for Enhanced Performance in Turbine Blade Internal Cooling
Open Access
- 25 November 2024
- journal article
- research article
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 147 (6) , 1-37
Abstract
Past experiments have consistently shown that V-shaped rib turbulators are among the best in heat transfer performance. While there is literature on the V rib design in various experimental studies, there is no literature that shows the V rib design applied on any current turbine blades. Instead, the straight and angled rib design are used. The V rib only offers a marginally better heat transfer performance over the angled rib, but it has a severe stress concentration at the rib tip. In this research, multiple design augmentations were analyzed, with the addition of a spline at the center of the V exhibiting alleviation of the tip stress concentration. The results show that the presence of the spline not only resolves the fatigue issues but also increases the heat transfer performance by 4.3% and 8.2% against the V rib and angled rib design, respectively. With a better heat transfer performance, the creep analysis shows that the turbine blade with a V-spline rib design can operate at temperatures 203 °C hotter than an angled rib at the same fluid power. Given the dependence of engine thermal efficiency on turbine inlet temperature, this simple design shows good potential for heat transfer augmentation.Keywords
This publication has 23 references indexed in Scilit:
- Heat transfer and friction in trapezoidal channels with X-shaped ribsInternational Journal of Thermal Sciences, 2021
- Improvement in thermal hydraulic performance by using continuous V and W-Shaped rib turbulators in gas turbine blade cooling applicationCase Studies in Thermal Engineering, 2021
- Experimental and numerical study of heat transfer due to developing flow in a two-pass rib roughened square ductInternational Journal of Heat and Mass Transfer, 2016
- Experimental investigation of heat transfer and flow using V and broken V ribs within gas turbine blade cooling passageHeat and Mass Transfer, 2014
- Turbine blade temperature calculation and life estimation - a sensitivity analysisPropulsion and Power Research, 2013
- Analysis of conjugated heat transfer, stress and failure in a gas turbine blade with circular cooling passagesEngineering Failure Analysis, 2011
- Failure analysis of a gas turbine blade made of Inconel 738LC alloyEngineering Failure Analysis, 2005
- High temperature isothermal and cyclic oxidation behavior of a single crystal Ni base superalloyJournal of Materials for Energy Systems, 1987
- An investigation of heat transfer and friction for rib-roughened surfacesInternational Journal of Heat and Mass Transfer, 1978
- Heat transfer and friction in tubes with repeated-rib roughnessInternational Journal of Heat and Mass Transfer, 1971