Influence of selective laser melting process parameters on the characteristics of SiC/Ti6Al4V(ELI) single tracks
Open Access
- 1 December 2022
- journal article
- research article
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 370, 01003
Abstract
Process parameters of selective laser melting, such as track height, track width and depth of penetration, affect the characteristics of laser fused single tracks. The properties of additively manufactured 3D parts depend strongly on the quality of laser melted single tracks and resultant single layers. Layers formed with a good depth of laser penetration provide strong bonding between consecutive layers and the substrate. Poor depth of laser penetration leads to delamination of layers. In this study the effect of the critical process parameters of laser power, laser scanning speed, and laser linear energy density on the characteristics of SiC/Ti6Al4V(ELI) single tracks at different SiC volume fractions (5 %, 10 %, 15 %, 20 %, 25 % and 30%) was investigated. Phenomena, such as the keyhole effect, pre-balling, and balling of single tracks, were also investigated. The obtained results showed that increase of power at a constant speed increase both the track width and depth of penetration but the track height above the substrate is decreased.Keywords
This publication has 12 references indexed in Scilit:
- Smoke Suppression in Electron Beam Melting of Inconel 718 Alloy Powder Based on Insulator–Metal Transition of Surface Oxide Film by Mechanical StimulationMaterials, 2021
- Single track and single layer formation in selective laser melting of niobium solid solution alloyChinese Journal of Aeronautics, 2018
- A Review on Melt‐Pool Characteristics in Laser Welding of MetalsAdvances in Materials Science and Engineering, 2018
- Production and mechanical properties of nano SiC particle reinforced Ti–6Al–4V matrix compositeTransactions of Nonferrous Metals Society of China, 2017
- On the limitations of Volumetric Energy Density as a design parameter for Selective Laser MeltingMaterials & Design, 2017
- PECULIARITIES OF SINGLE TRACK FORMATION FROM TI6AL4V ALLOY AT DIFFERENT LASER POWER DENSITIES BY SELECTIVE LASER MELTINGSouth African Journal of Industrial Engineering, 2015
- Characterization of Silicon Carbide Reinforced Aluminum Matrix CompositesProcedia Engineering, 2014
- Scanning Space Analysis in Selective Laser Melting for CoCrMo PowderProcedia Engineering, 2013
- A study of the microstructural evolution during selective laser melting of Ti–6Al–4VActa Materialia, 2010
- Improvement of hardness and wear resistance in SiC/Ti–6Al–4V surface composites fabricated by high-energy electron beam irradiationMaterials Science and Engineering: A, 2003