Effects of Cutting Edge Radius on Surface Integrity in Machining of Nickel-Based Cast Superalloy: An In Situ Imaging Approach
- 25 August 2022
- journal article
- research article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 144 (12)
Abstract
Cutting edge radius is a crucial factor affecting surface integrity during metal machining, which determines product performance. However, the exact mechanism of how the cutting edge radius affects machined surface has not yet been understood, especially lacking in situ evidence during the material removal process. In this article, effects of cutting edge radius on surface roughness, subsurface deformation, and work hardening of nickel-based cast superalloy are studied through an in situ imaging approach. Based on continuous high-speed filming and digital imaging correlation (DIC) techniques, detailed chip formation and quantitative subsurface plastic deformation under various cutting edge radii are analyzed, and the formation of built-up edge (BUE) is observed when using a large edge radius. Furthermore, when the cutting edge radius is greater than the uncut chip thickness (h), the thickness of plastic deformation increases dramatically. On the other hand, the machined surface roughness can be improved when the cutting edge radius is between 30% and 60% of h. The sharp cutting tools or the cutting edge radius higher than 60% of h result in a poor surface quality on the machined surface during nickel-based cast superalloy machining. The effects of cutting edge radius on machined surface generation are systematically categorized as cutting with chipping, cutting with significant plowing, and cutting with plowing accompanied by BUE formation.Keywords
Funding Information
- National Natural Science Foundation of China (92160207, 52005200, 52188102)
This publication has 46 references indexed in Scilit:
- Machining induced surface integrity in titanium and nickel alloys: A reviewInternational Journal of Machine Tools and Manufacture, 2011
- Control of deformation levels on machined surfacesCIRP Annals, 2011
- Cutting Edge Preparation by Means of Abrasive BrushingKey Engineering Materials, 2010
- Links Between Machining Parameters and Surface Integrity in Drilling Ni-SuperalloyAdvanced Materials Research, 2010
- Finite Elements in Small‐Strain Plasticity Problems2008
- Influence of tool sharpness on the thermal and mechanical phenomena generated during machining operationsInternational Journal of Machining and Machinability of Materials, 2007
- Key improvements in the machining of difficult-to-cut aerospace superalloysInternational Journal of Machine Tools and Manufacture, 2005
- An example of selection of the cutting conditions in broaching of heat-resistant alloys based on cutting forces, surface roughness and tool wearJournal of Materials Processing Technology, 2005
- Workpiece Surface Integrity and Tool Life Issues When Turning Inconel 718™ Nickel Based SuperalloyMachining Science and Technology, 2004
- The assessment of plastic deformation in metal cuttingJournal of Materials Processing Technology, 2004