Study on microstructure, rheological, and mechanical properties of cellulose short fiber reinforced TPVs based on EPDM/PP
Authors:
- 18 June 2008
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 30 (2) , 182-187
Abstract
The morphology, rheology, and mechanical properties of the dynamically vulcanized thermoplastic elastomer based on EPDM/PP (60/40, w:w) containing 5, 10, and 20% of cellulose short fiber were studied. From the results it was found that addition of 5% of cellulose fiber has no significant effect on the maximum torque associated with the dynamic vulcanization stage, while higher concentration of fibers decreased the maximum torque. These results were explained in terms of influence of cellulose fibers on the extent of agglomeration formed between the cured rubber particles. The results of tensile test performed on the samples showed that incorporation of 5% of cellulose fibers into the sample has an increasing effect on elongation at break with no appreciable change in tensile behavior. However increasing the cellulose fibers content of the sample to 20% had a remarkable change in tensile properties of the sample resulting in a toughened plastic type behavior. The melt elasticity of the sample containing 5% of cellulose fibers particularly at low shear rate range was found to be lower than that of the sample without fibers indicating the role of fibers in weakening of cured rubber particle agglomeration. This was supported with the results of the relaxation time distribution H(λ) and scanning electron microscopy of the samples. POLYM. COMPOS., 2009. © 2008 Society of Plastics EngineersKeywords
This publication has 12 references indexed in Scilit:
- Relationship between the rheology and morphology of dynamically vulcanized thermoplastic elastomers based on EPDM/PPPolymer Engineering & Science, 2004
- Silica‐reinforced dynamically vulcanized ethylene–propylene–diene monomer/polypropylene thermoplastic elastomers: Morphology, rheology, and dynamic mechanical propertiesJournal of Applied Polymer Science, 2004
- Formation of Rubber Particle Agglomerates During Morphology Development in Dynamically Crosslinked EPDM/PP Thermoplastic Elastomers. Part 1: Effects of Processing and Polymer Structural ParametersRubber Chemistry and Technology, 2003
- Mechanism of morphology development in dynamically cured EPDM/PP TPEs. I. Effects of state of cureJournal of Applied Polymer Science, 2001
- Morphology of Elastomeric AlloysRubber Chemistry and Technology, 1991
- Polyolefin Thermoplastic Elastomer BlendsRubber Chemistry and Technology, 1991
- Mechanical Properties, Structure, and Morphology of Natural-Rubber/Low-Density Polyethylene Blends Prepared by Different Processing MethodsRubber Chemistry and Technology, 1990
- Structure and properties of dynamically cured EPDM/PP blendsJournal of Applied Polymer Science, 1986
- Dynamic mechanical properties of thermoplastic elastomers from polypropylene–natural rubber blendJournal of Applied Polymer Science, 1986
- Rubber-Thermoplastic Compositions. Part I. EPDM-Polypropylene Thermoplastic VulcanizatesRubber Chemistry and Technology, 1980