Bearing Capacities of Different-Diameter Concrete-Filled Steel Tubes under Axial Compression
Open Access
- 26 December 2016
- journal article
- research article
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2016, 1-10
Abstract
The bearing capacities of concrete-filled steel tubes are normally derived through experiments with small-scale specimens, but it is uncertain whether such derivations are appropriate for the much larger components used in practical engineering. This study therefore investigates the effect of different diameters (219, 426, 630, and 820 mm) on the axial compression of short concrete columns in steel (Q235) tubes. It is found that the peak nominal stress decreases with increasing specimen size and that the axial bearing capacity is determined by three separate components: the cylinder compressive strength of the concrete, the improvement in strength due to the confining effect of the steel tube, and the longitudinal strength of the steel tube. At peak load, increases in the specimen diameter reduce the hoop stresses in the steel tube, thereby reducing the strengthening effect of confinement. Vertical stress in the steel tube is increased with diameter; therefore, the axial bearing capacity of the steel tube is directly related to the specimen size. Size effect coefficients for these three aspects of bearing capacity are defined and used to develop a size-dependent model for predicting the axial bearing capacity of large, concrete-filled steel tubes. The model is then validated against experimental data.Keywords
Funding Information
- Key Laboratory Open Fund of Urban Safety and Disaster Reduction (2013ZD02, 50838001)
- National Natural Science Foundation of China (2013ZD02, 50838001)
This publication has 13 references indexed in Scilit:
- Size effect of confined concrete subjected to axial compressionJournal of Central South University, 2014
- Triaxial Behavior of Concrete Subjected to Dynamic CompressionJournal of Structural Engineering, 2013
- EXPERIMENTAL STUDY ON THE EFFECT OF CROSS SECTIONAL SIZE AND SHAPE ON COMPRESSIVE CHARACTERISTICS OF CONCRETE FILLED SQUARE STEEL TUBE SHORT COLUMNSJournal of Structural and Construction Engineering (Transactions of AIJ), 2013
- Size Effect of Concrete Short Columns Confined with Aramid FRP JacketsJournal of Composites for Construction, 2011
- Nonlinear analysis of circular concrete-filled steel tubular short columns under axial loadingJournal of Constructional Steel Research, 2009
- Performance-based analysis of concrete-filled steel tubular beam–columns, Part I: Theory and algorithmsJournal of Constructional Steel Research, 2009
- Experimental investigation of size effect in concrete fracture under multiaxial compressionInternational Journal of Fracture, 2006
- Behavior of Centrally Loaded Concrete-Filled Steel-Tube Short ColumnsJournal of Structural Engineering, 2004
- Lateral Confinement Needed to Suppress Softening of Concrete in CompressionJournal of Engineering Mechanics, 2002
- Size Effect in Compression Fracture: Splitting Crack Band PropagationJournal of Engineering Mechanics, 1997