Wenjing Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Wenjing Wang has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
Hua Ma
Beijing University of Technology, Key Laboratory of Urban Security and Disaster Engineering of Education Ministry, Beijing, China
1 shared publication- Yueqing Yu
College of Mechanical Engineering and Applied Electronics Technology, Beijing University of Technology, Beijing, China
1 shared publication - Zhenbao Li
The Key Laboratory of Urban Security and Disaster Engineering, Ministry of Education, Beijing University of Technology, Beijing 100124, China
1 shared publication - Zhenyun Tang
The Key Laboratory of Urban Security and Disaster Engineering of the Ministry of Education, Beijing University of Technology, Beijing 100124, China
1 shared publication Zhonglei Feng
Beijing University of Technology
1 shared publication
Latest Publications
- Open Access
- 26 December 2016
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2016, 1-10
Bearing Capacities of Different-Diameter Concrete-Filled Steel Tubes under Axial Compression
The bearing capacities of concrete-filled steel tubes are normally derived through experiments with small-scale specimens, but it is uncertain whether such derivations are appropriate for the much larger components used in practical engineering. This study therefore investigates the effect of different diameters (219, 426, 630, and 820 mm) on the axial compression of short concrete columns in steel (Q235) tubes. It is found that the peak nominal stress decreases with increasing specimen size and that the axial bearing capacity is determined by three separate components: the cylinder compressive strength of the concrete, the improvement in strength due to the confining effect of the steel tube, and the longitudinal strength of the steel tube. At peak load, increases in the specimen diameter reduce the hoop stresses in the steel tube, thereby reducing the strengthening effect of confinement. Vertical stress in the steel tube is increased with diameter; therefore, the axial bearing capacity of the steel tube is directly related to the specimen size. Size effect coefficients for these three aspects of bearing capacity are defined and used to develop a size-dependent model for predicting the axial bearing capacity of large, concrete-filled steel tubes. The model is then validated against experimental data.
- 26 December 2016
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2016, 1-10
Open AccessBearing Capacities of Different-Diameter Concrete-Filled Steel Tubes under Axial Compression
The bearing capacities of concrete-filled steel tubes are normally derived through experiments with small-scale specimens, but it is uncertain whether such derivations are appropriate for the much larger components used in practical engineering. This study therefore investigates the effect of different diameters (219, 426, 630, and 820 mm) on the axial compression of short concrete columns in steel (Q235) tubes. It is found that the peak nominal stress decreases with increasing specimen size and that the axial bearing capacity is determined by three separate components: the cylinder compressive strength of the concrete, the improvement in strength due to the confining effect of the steel tube, and the longitudinal strength of the steel tube. At peak load, increases in the specimen diameter reduce the hoop stresses in the steel tube, thereby reducing the strengthening effect of confinement. Vertical stress in the steel tube is increased with diameter; therefore, the axial bearing capacity of the steel tube is directly related to the specimen size. Size effect coefficients for these three aspects of bearing capacity are defined and used to develop a size-dependent model for predicting the axial bearing capacity of large, concrete-filled steel tubes. The model is then validated against experimental data.
- 21 May 2010
- Published by Springer Nature in Frontiers of Mechanical Engineering in China
- Vol. 5 (3) , 294-301
Modeling of large-deflection links for compliant mechanisms
- 21 May 2010
- Published by Springer Nature in Frontiers of Mechanical Engineering in China
- Vol. 5 (3) , 294-301
Modeling of large-deflection links for compliant mechanisms