Accessible Fabrication and Functional Characterization of Polyethersulfone Ultrafiltration Membranes: Effects of NIPS Processing Conditions on Permeability and MWCO
Authors:
Open Access
Abstract
Polyethersulfone (PES) ultrafiltration membranes were fabricated by non-solvent-induced phase separation (NIPS) and characterized through water permeability and molecular weight cut-off (MWCO) measurements. The influence of polymer concentration, coagulation bath temperature, and casting thickness on membrane performance was investigated using accessible characterization methodologies. A total of 27 membrane fabrication experiments were conducted using three PES concentrations (18, 20, and 22 wt.%), three coagulation bath temperatures (6, 8, and 10 °C), and three nominal casting thicknesses (60, 75, and 90 μm). Water permeability ranged from approximately 9 to 80 L m−2 h−1 bar−1, demonstrating a strong influence of fabrication conditions on membrane performance. Polymer concentration was identified as the dominant factor controlling both permeability and MWCO. Increasing PES concentration produced membranes with lower permeability and lower MWCO values, consistent with the reduction in effective pore size, although direct morphological characterization was beyond the scope of this study. Coagulation bath temperature significantly affected both permeability and selectivity, whereas casting thickness significantly affected permeability but showed no significant influence on MWCO. Statistical analysis further revealed a significant interaction between polymer concentration and coagulation bath temperature for MWCO. The results demonstrated a clear permeability–selectivity trade-off characteristic of ultrafiltration membranes prepared by NIPS. Furthermore, the combined use of permeability and MWCO measurements provided sufficient information to identify the effects of fabrication parameters on membrane performance, highlighting the usefulness of accessible characterization methodologies for membrane development, optimization, and technology transfer.Keywords
Funding Information
- International Development Research Centre, Canada
- UNESCO (109755-001)
This publication has 51 references indexed in Scilit:
- Impact of solvents and process conditions on the formation of polyethersulfone membranes and its fouling behavior in lake water filtrationJournal of Chemical Technology & Biotechnology, 2015
- Properties of polyethersulfone ultrafiltration membranes modified with polyethylene glycolsPolymer Engineering & Science, 2013
- Effects of adding different ethanol amines during membrane preparation on the performance and morphology of nanoporous PES membranesJournal of Polymer Research, 2012
- Membrane Technology and Applications2012
- Effects of coagulation bath temperature and polyvinylpyrrolidone content on flat sheet asymmetric polyethersulfone membranesPolymer Engineering & Science, 2009
- Preparation and characterization of asymmetric polyethersulfone (PES) membranesPolymers for Advanced Technologies, 2009
- Effect of type of solvent and non-solvents on morphology and performance of polysulfone and polyethersulfone ultrafiltration membranes for milk concentrationPolymers for Advanced Technologies, 2005
- Membrane formation via phase separation induced by penetration of nonsolvent from vapor phase. I. Phase diagram and mass transfer processJournal of Applied Polymer Science, 1999
- Basic Principles of Membrane Technology1996
- An appropriate molecular size parameter for porous membranes calibrationJournal of Membrane Science, 1995