Study on ultrafine-grained aluminum matrix nanocomposite joint fabricated by friction stir welding
- 10 February 2015
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications
- Vol. 230 (1) , 311-318
Abstract
The aim of this study is to investigate the effect of adding Al2O3 nanoparticles on the properties of joints fabricated by friction stir welding. The joints were characterized by optical microscopy, scanning electron microscopy, dry sliding wear test, and potentiodynamic polarization test. The results show that the average grain size was reduced in the nugget zone after the addition of nanoparticles. The produced welds were also found to have adequate wear and corrosion resistance. This work demonstrates that adding Al2O3 nanoparticle is an effective strategy for improving the properties of the joints produced by friction stir welding.Keywords
This publication has 42 references indexed in Scilit:
- Modelling and Pareto optimization of mechanical properties of friction stir welded AA7075/AA5083 butt joints using neural network and particle swarm algorithmMaterials & Design (1980-2015), 2013
- Influence of Tool Pin Profiles on Friction Stir Welding of CopperMaterials and Manufacturing Processes, 2012
- Effect of processing parameters on fabrication of Al–Mg/Cu composites via friction stir processingMaterials & Design (1980-2015), 2012
- Investigation on Joining of Aluminum and Mild Steel by Friction Stud WeldingMaterials and Manufacturing Processes, 2012
- Experimental Investigation of Material Flow and Welding Defects in Friction Stir Welding of Aluminum to BrassMaterials and Manufacturing Processes, 2012
- The role of Metal-Matrix Composite development During Friction Stir Welding of Aluminum to Brass in Weld CharacteristicsJournal of Materials Engineering and Performance, 2012
- Study on dissimilar friction stir butt welding of AA7075-O and AA2024-T4 considering the manufacturing limitationThe International Journal of Advanced Manufacturing Technology, 2011
- Material flow in heterogeneous friction stir welding of aluminium and copper thin sheetsScience and Technology of Welding and Joining, 2010
- Process optimisation and mechanical properties of friction stir lap welds of 7075-T6 stringers on 2024-T3 skinMaterials & Design (1980-2015), 2010
- Numerical analysis of the dwell phase in friction stir welding and comparison with experimental dataMaterials Science and Engineering: A, 2010