Raster Orientation Effects on the Adhesion of iCVD-Deposited PSA Thin Films on FDM-Printed PLA
Open Access
Abstract
The adhesion performance of pressure-sensitive adhesive (PSA) thin films on additively manufactured polymers is strongly governed by surface anisotropy induced during printing. In this study, PSA thin films based on 2-ethylhexyl acrylate (EHA) and acrylic acid (AA) were deposited by initiated chemical vapor deposition (iCVD) onto fused deposition modeling (FDM) printed PLA substrates with different raster orientations (0°, 30°, 60°, and 90°). The deposited films exhibited high optical transparency on glass, and thicknesses consistent with the targeted deposition. Adhesion performance was evaluated using tensile and three-point bending tests, revealing a strong dependence on raster orientation. The 0° raster orientation yielded the highest shear adhesion strengths, reaching 12.03 N/cm2 under tensile loading and 4.59 N/cm2 under bending, along with the largest failure displacements. In contrast, specimens printed at 90° exhibited an approximately 47% reduction in tensile shear adhesion strength and limited deformation prior to failure. SEM analysis showed that raster alignment parallel to the loading direction promoted extensive adhesive deformation and PSA fibrillation, whereas higher raster angles resulted in predominantly interfacial debonding. These results demonstrate that raster orientation is a critical design parameter for tuning PSA adhesion on FDM-printed PLA substrates without modifying adhesive chemistry.Keywords
Funding Information
- Konya Technical University Scientific Research Foundation (252216042)
- Scientific and Technological Research Council of Türkiye (TÜBİTAK) BİDEB (124C127)
This publication has 35 references indexed in Scilit:
- Pressure-sensitive adhesive thin films with tailored properties via solvent-free plasma deposition of EHA/AA copolymersApplied Surface Science, 2025
- Effects of surface pattern strategies on roughness and mechanical properties of additively manufactured structuresColloids and Surfaces A: Physicochemical and Engineering Aspects, 2025
- Advanced Morphological Control of Polymeric Surfaces Using Initiated Chemical Vapor Deposition (iCVD)Advanced Functional Materials, 2024
- Pressure-sensitive acrylic adhesives (PSAs): how it began and the present state of artChemTexts, 2024
- Designing Organic and Hybrid Surfaces and Devices with Initiated Chemical Vapor Deposition (iCVD)Advanced Materials, 2023
- Effects of raster angle on tensile and surface roughness properties of various FDM filamentsJournal of Mechanical Science and Technology, 2021
- Vapor deposition of stable copolymer thin films in a batchiCVDreactorJournal of Applied Polymer Science, 2020
- All‐Dry Hydrophobic Functionalization of Paper Surfaces for Efficient Transfer of CVD GrapheneMacromolecular Chemistry and Physics, 2019
- Bond interface design for single lap joints using polymeric additive manufacturingComposite Structures, 2017
- Effect of layer thickness and print orientation on strength of 3D printed and adhesively bonded single lap jointsJournal of Mechanical Science and Technology, 2017