Effect of the substrate bias voltage on the physical characteristics of copper films deposited by microwave plasma-assisted sputtering technique
Authors:
- 13 November 2003
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 22 (1) , 30-35
Abstract
Pure copper films have been deposited by microwave plasma-assisted sputtering on (100)-oriented single crystal silicon substrates mounted on a water-cooled substrate holder either maintained at the floating potential or biased to various dc voltages ranging from 0 to −125 V. The argon pressure was fixed at 0.13 Pa and argon ions from the discharge produced in a distributed electron cyclotron resonance microwave plasma chamber were used for sputtering of a copper target biased to −600 V. The crystallographic structure and surface morphology of copper films were determined by x-ray diffraction techniques and atomic force microscopy, respectively. The magnitude of residual stresses developed in these films was calculated from the radius of curvature of Si substrates. The electrical resistivity of films was deduced from the thickness and sheet resistance of films determined by profilometry and four point probe measurements. The evolution of the deposition rate, surface roughness, microstructure, magnitude of residual stresses, and electrical resistivity of films was investigated as a function of the substrate bias voltage. The major characteristics of copper films were found to vary significantly as the negative substrate bias voltage increased from −40 to −125 V or with increasing argon ion energy. The resputtering process of a fraction of copper atoms by energetic incident argon ions was responsible for the modification of characteristics of films deposited on biased substrates. The quality of copper films in terms of surface morphology and electrical resistivity in particular was found to be excellent for incident argon ion energy values lower than 70 eV.Keywords
This publication has 13 references indexed in Scilit:
- Abnormal grain growth in {111} textured Cu thin filmsThin Solid Films, 2002
- Development of 〈110〉 texture in copper thin filmsApplied Physics Letters, 2002
- Structural and electrical properties of copper thin films prepared by filtered cathodic vacuum arc techniqueSurface and Coatings Technology, 2001
- Improved TiN film as a diffusion barrier between copper and siliconThin Solid Films, 1998
- Comparative study of tantalum and tantalum nitrides (Ta2N and TaN) as a diffusion barrier for Cu metallizationJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 1996
- Relationship of crystallographic orientation and impurities to stress, resistivity, and morphology for sputtered copper filmsJournal of Vacuum Science & Technology A, 1993
- Effect of deposition technique on the As-deposited microstructure of copper thin filmsJournal of Vacuum Science & Technology A, 1992
- Stress measurement in sputtered copper films on flexible polyimide substratesJournal of Vacuum Science & Technology A, 1987
- The angular distribution of particles sputtered from Cu, Zr, and Au surfaces by ion bombardment at grazing incidenceNuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 1985
- Effects of argon pressure on the structure of dc cylindrical magnetron sputtered thin copper filmsJournal of Vacuum Science and Technology, 1981