An Enhanced Electro-Thermal Coupled Model With Lithium Plating Detection for Lithium-Ion Battery at Low Temperatures
- 17 May 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Transportation Electrification
- Vol. 10 (1) , 720-734
Abstract
Lithium plating may occur when lithium-ion batteries are charged at a high current rate and low ambient temperature. As a result, the battery degradation is accelerated and the risk of thermal runaway is increased. Along these lines, an enhanced electro-thermal model was proposed in this work for charging at low temperature values. By considering the battery with a reference electrode, a dual RC model was built. The developed model can predict the anode potential to prevent the lithium plating. The thermal model and absolute state of charge (SOC) were integrated into the battery model to solve the SOC inconsistency caused by the battery temperature rise during the charging process. Then, the proposed electro-thermal model was used to predict the electrical and thermal characteristics of a 50 Ah battery under various charging rates and low ambient temperature values conditions. In addition, the prediction results were validated by the experiment data. The maximum errors of the cathode potential and battery terminal voltage were 0.058 V and 0.154 V, respectively, whereas the maximum cell temperature error was 0.88 °C. Based on the anode prediction electro-thermal coupling model, a segmented heating strategy without lithium plating was proposed to describe the fast battery charging procedure, which can reduce energy consumption by 16.1% and save charging time by nearly 10 minutes compared with the continuous high-power heating mode.Keywords
Funding Information
- NSF of China (U20A20310, U1864212, 52072052)
- Fundamental Research Funds for the Central Universities (2021CDJQY-050)
- National key research and development program (2021YFE0193800)
- Guangdong Provincial Department of Science and Technology (2020B0909030001)
This publication has 25 references indexed in Scilit:
- Optimization of low-temperature preheating strategy for Li-ion batteries with supercooling phase change materials using response surface methodInternational Communications in Heat and Mass Transfer, 2023
- Electrochemical modeling and parameterization towards control-oriented management of lithium-ion batteriesControl Engineering Practice, 2022
- Electrochemical modeling and parameter sensitivity of lithium-ion battery at low temperatureJournal of Energy Storage, 2021
- An investigation on electrical and thermal characteristics of cylindrical lithium-ion batteries at low temperaturesEnergy, 2021
- Fast charging lithium-ion battery formation based on simulations with an electrode equivalent circuit modelJournal of Energy Storage, 2021
- Hybridized time-frequency method for the measurement of entropy coefficient of lithium-ion batteryElectrochimica Acta, 2020
- A dynamic electro‐thermal coupled model for temperature prediction of a prismatic battery considering multiple variablesInternational Journal of Energy Research, 2020
- An improved electro-thermal battery model complemented by current dependent parameters for vehicular low temperature applicationApplied Energy, 2019
- Kinetic study of low temperature capacity fading in Li-ion cellsJournal of Energy Storage, 2017
- Electrochemical impedance study on the low temperature of Li-ion batteriesElectrochimica Acta, 2004