Transient Characteristics of a Closed-Loop Pipe System During Pump Stopping Periods
- 7 January 2014
- journal article
- Published by ASME International in Journal of Pressure Vessel Technology
- Vol. 136 (2) , 021301
Abstract
In order to study the transient characteristics of a closed-loop pipe system with room temperature water, experiments were carried out based on different pump stopping periods from rate rotational speed to zero. Various stopping periods were realized by changing the rotational inertia of the rotors, controlling the frequency of the motor and braking the shaft. Experimental results of different operating schemes were compared, and transient flow rate of the pipe system and transient characteristics of the pump were analyzed. The influences of the kinetic energy of the loop fluid and pump rotors to the stopping periods were summarized. Results show that rapid change of the pump operating conditions occurs during the stopping period and transient flow rate of the pipe system and characteristics of the pump depend largely on the way of stopping. The kinetic energy stored in the pump can drive the impeller keeping rotating for more time after the motor is shutdown. Due to the kinetic energy stored in the loop pipe, the flow rate does not reach zero immediately after the rotational speed reaches zero. The inertia of pump rotor and fluid inertia affect the impact of fluid flow and the duration of the loop during pump stopping period.Keywords
This publication has 13 references indexed in Scilit:
- Numerical Simulation of the Transient Flow in a Radial Flow Pump during Stopping PeriodJournal of Fluids Engineering, 2011
- The transient flow in a centrifugal pump during the discharge valve rapid opening processNuclear Engineering and Design, 2010
- Numerical Simulation of the Transient Flow in a Centrifugal Pump During Starting PeriodJournal of Fluids Engineering, 2010
- Fluid dynamic interaction between water hammer and centrifugal pumpsNuclear Engineering and Design, 2009
- Analysis of the capability of system codes to model cavitation water hammers: Simulation of UMSICHT water hammer experiments with TRACE and RELAP5Nuclear Engineering and Design, 2008
- Transient Behavior of Turbomachineries: Applications to Radial Flow Pump StartupsJournal of Fluids Engineering, 2007
- Use of Steady-State Pump Head-Discharge Curve for Unsteady Pipe Flow ApplicationsJournal of Hydraulic Engineering, 2003
- Transient Analysis with Time-Decoupled Pumping StationJournal of Hydraulic Engineering, 1998
- Transient Characteristics of a Centrifugal Pump During Stopping PeriodJournal of Fluids Engineering, 1986
- Transient Characteristics of a Centrifugal Pump During Starting PeriodJournal of Fluids Engineering, 1982