Effect of Grease Composition on Impact-Sliding Wear
Open Access
- 4 August 2024
- journal article
- research article
- Published by MDPI AG in Lubricants
- Vol. 12 (8) , 279
Abstract
Impact-sliding experiments were performed by using four self-made lithium-based greases, namely Yangtze Grease 1, Yangtze Grease 2, Yangtze Grease 3, and Yangtze Grease 4. The influence of base oil viscosity, thickener content, and morphology of thickener fiber clusters on the lubricating state were visually explored, combined with field-emission microscopy and two-light interference technology. The grease film distribution at the middle section was measured using Dichromatic Interference Intensity Modulation (DIIM) software. All experiments were executed in a completely flooded environment. The results show that among the components of grease, the base oil’s viscosity has the greatest impact on the anti-wear performance of the grease. As the viscosity of the base oil increases, the grease exhibits better anti-wear performance. The grease film thickness under the condition of high-viscosity base oil is about 10 times higher than that under the condition of low-viscosity base oil. Secondly, the content of thickener in the grease needs to be controlled within a reasonable range. The experiments indicate that the effect of thickener content on the grease’s film-forming properties becomes more pronounced at higher speeds. From the experiment using YG 4, it can be seen that a higher thickener content under high-speed conditions increases the thickness of the lubricating grease film by about 10 times. The dimensions of the thickener fibers and the density of their entanglement structure significantly influence the rheological properties and load-bearing capacity of the grease. Larger fiber sizes and higher entanglement densities result in reduced grease fluidity and recovery but enhance its load-bearing capabilities. In order to obtain the best anti-wear performance during impact-sliding motion, the size of the thickener fiber and the density of the entanglement structure need to be controlled within an appropriate range.Keywords
Funding Information
- National Natural Science Foundation of China (51875298, ZR2019MEE040)
- Natural Science Foundation of Shandong Province (51875298, ZR2019MEE040)
This publication has 40 references indexed in Scilit:
- Failure of high-speed bearing at cyclic impact-sliding contacts: Numerical and experimental analysisInternational Journal of Mechanical Sciences, 2023
- Impact wear behavior of ball burnished 316L stainless steelSurface and Coatings Technology, 2019
- The influence of bearing grease composition on friction in rolling/sliding concentrated contactsTribology International, 2016
- Effect of Thickener Particle Geometry and Concentration on the Grease EHL Film Thickness at Medium SpeedsTribology Letters, 2016
- A Dichromatic Interference Intensity Modulation Approach to Measurement of Lubricating Film ThicknessTribology Letters, 2015
- Film thickness in grease lubricated slow rotating rolling bearingsTribology International, 2014
- EHL with Grease at Low Speeds2009
- Grease lubrication of rolling element bearings — role of the grease thickenerLubrication Science, 2007
- The transition between fully flooded and starved regimes in EHLTribology International, 2004
- Study of lubricated impact using optical interferometryWear, 1995