Analysis and implementation of a new single‐switch buck–boost DC/DC converter
Open Access
- 1 July 2014
- journal article
- research article
- Published by Institution of Engineering and Technology (IET) in IET Power Electronics
- Vol. 7 (7) , 1906-1914
Abstract
In this study, a novel buck–boost DC/DC converter is presented. The circuit structure of the proposed converter consists of a single power switch, two diodes and some energy storage elements. Employing only a single power switch reduces the implementation cost and switching power losses. The proposed converter has higher voltage gain in step‐up mode in comparison with conventional buck–boost and Cuk converter. In addition, this converter expands the continuous conduction mode (CCM) operational region. The presented converter has three operation modes in CCM. The second mode reduces the voltage stresses across the capacitors. Therefore the current stresses on diodes are also reduced. To verify the operation of the proposed converter, the experimental results are provided using a hardware prototype.Keywords
This publication has 14 references indexed in Scilit:
- Voltage Gain Enhancement for a Step-Up Converter Constructed by KY and Buck-Boost ConvertersIEEE Transactions on Industrial Electronics, 2013
- Non-inverting buck–boost converter with interleaved technique for fuel-cell systemIET Power Electronics, 2012
- A Novel Buck–Boost Converter Combining KY and Buck ConvertersIEEE Transactions on Power Electronics, 2011
- Multi-output buck–boost converter with enhanced dynamic response to load and input voltage changesIET Power Electronics, 2011
- Analysis, Design, and Control of Bidirectional Cascoded Configuration for a Fuel Cell Hybrid Power SystemIEEE Transactions on Power Electronics, 2009
- Two Types of KY Buck–Boost ConvertersIEEE Transactions on Industrial Electronics, 2009
- Buck-Boost Converter for Sensorless Power Optimization of Piezoelectric Energy HarvesterIEEE Transactions on Power Electronics, 2007
- Current programmed control of a single-phase two-switch buck-boost power factor correction circuitIEEE Transactions on Industrial Electronics, 2006
- Positive Output Multiple-Lift Push–Pull Switched-Capacitor Luo-ConvertersIEEE Transactions on Industrial Electronics, 2004
- A Low Voltage, Dynamic, Noninverting, Synchronous Buck-Boost Converter for Portable ApplicationsIEEE Transactions on Power Electronics, 2004