Nonlinear Dynamic Analysis of the Cutting Process of a Nonextensible Composite Boring Bar
Open Access
- 28 October 2020
- journal article
- research article
- Published by Wiley in Shock and Vibration
- Vol. 2020, 1-13
Abstract
A nonlinear dynamic analysis of the cutting process of a nonextensible composite cutting bar is presented. The cutting bar is simplified as a cantilever with plane bending. The nonlinearity is mainly originated from the nonextensible assumption, and the material of cutting bar is assumed to be viscoelastic composite, which is described by the Kelvin–Voigt equation. The motion equation of nonlinear chatter of the cutting system is derived based on the Hamilton principle. The partial differential equation of motion is discretized using the Galerkin method to obtain a 1-dof nonlinear ordinary differential equation in a generalized coordinate system. The steady forced response of the cutting system under periodically varying cutting force is approximately solved by the multiscale method. Meanwhile, the effects of parameters such as the geometry of the cutting bar (including length and diameter), damping, the cutting coefficient, the cutting depth, the number of the cutting teeth, the amplitude of the cutting force, and the ply angle on nonlinear lobes and primary resonance curves during the cutting process are investigated using numerical calculations. The results demonstrate that the critical cutting depth is inversely proportional to the aspect ratio of the cutting bar and the cutting force coefficient. Meanwhile, the chatter stability in the milling process can be significantly enhanced by increasing the structural damping. The peak of the primary resonance curve is bent toward the right side. Due to the cubic nonlinearity in the cutting system, primary resonance curves show the characteristics of typical Duffing’s vibrator with hard spring, and jump and multivalue regions appear.Keywords
Funding Information
- National Natural Science Foundation of China (11672166)
This publication has 28 references indexed in Scilit:
- Design and manufacture of a carbon fiber epoxy rotating boring barComposite Structures, 2003
- Suppression of chatter vibration of boring tools using impact dampersInternational Journal of Machine Tools and Manufacture, 2000
- Analytical Prediction of Chatter Stability in Milling—Part II: Application of the General Formulation to Common Milling SystemsJournal of Dynamic Systems, Measurement, and Control, 1998
- Analytical Prediction of Chatter Stability in Milling—Part I: General FormulationJournal of Dynamic Systems, Measurement, and Control, 1998
- Development of a composite boring barComposite Structures, 1997
- An Analytical Model of Cutting Dynamics. Part 1: Model BuildingJournal of Engineering for Industry, 1985
- Effect of a Variable Stiffness-Type Dynamic Damper on Machine Tools with Long Overhung RamBulletin of JSME, 1976
- A Theory of Nonlinear Regenerative ChatterJournal of Engineering for Industry, 1974
- On the Cause of Regenerative Chatter Due to Workpiece DeflectionJournal of Engineering for Industry, 1974
- Theory of Self-Excited Machine-Tool Chatter: Contribution to Machine-Tool Chatter Research—1Journal of Engineering for Industry, 1965