Analysis of the microtensile bond strength to enamel of two adhesive systems polymerized by halogen light or LED
Open Access
- 1 December 2005
- journal article
- Published by FapUNIFESP (SciELO) in Brazilian Oral Research
- Vol. 19 (4) , 307-311
Abstract
With the development of composite resin polymerization techniques, LEDs were introduced to the market place. Based on the studied literature, the aim of this study was to evaluate, through microtensile testing, the bond strength to enamel of a composite resin associated to a conventional (multi-bottle) adhesive system or to a self etching primer adhesive system, polymerized by halogen light or LED (light emitting diode). Bovine teeth were divided into 4 groups with 10 teeth each (n = 10). Then the adhesives Scotchbond Multipurpose Plus (3M-ESPE) and Clearfil SE Bond (Kuraray) were applied following the manufacturers’ instructions. Both systems were polymerized for 10 s by halogen light (Degulux Soft Start - Degussa Hulls) set at 550 mW/cm² or by LED (Kerr Demetron) set at 600 mW/cm². The composite resin Filtek Z-250 was applied in four 1 mm increments with the aid of a square, condensation silicon, 5 mm x 5 mm matrix, and polymerized by either of light sources for 40 s. Scotchbond Multipurpose Plus polymerized by halogen light presented the highest bond strength values (39.69 ± 7.07 MPa), and the other groups did not present statistically significant differences: Scotchbond Multipurpose Plus polymerized by LED (22.28 ± 2.63 MPa), Clearfil SE Bond polymerized by halogen light (27.82 ± 2.65 MPa) and by LED (22.89 ± 5.09 MPa).Keywords
This publication has 13 references indexed in Scilit:
- Effect of irradiation type (LED or QTH) on photo‐activated composite shrinkage strain kinetics, temperature rise, and hardnessEuropean Journal of Oral Sciences, 2002
- Polymerization Efficiency of LED Curing LightsJournal of Esthetic and Restorative Dentistry, 2002
- A comparison of polymerization by light-emitting diode and halogen-based light-curing unitsThe Journal of the American Dental Association, 2002
- Bond strength of composite to dentin using conventional, one-step, and self-etching adhesive systemsJournal of Dentistry, 2001
- Depth of cure and compressive strength of dental composites cured with blue light emitting diodes (LEDs)Dental Materials, 2000
- Tensile bond strength to and SEM evaluation of ground and intact enamel surfacesJournal of Dentistry, 1999
- Dental composite depth of cure with halogen and blue light emitting diode technologyBritish Dental Journal, 1999
- Regional bond strengths of resins to human root dentineJournal of Dentistry, 1996
- The Relationship between Composition and Properties of Posterior Resin CompositesJournal of Dental Research, 1990
- Bovine Teeth as Possible Substitutes in the Adhesion TestJournal of Dental Research, 1983