Erosive Wear Behavior of Fiberglass-Reinforced Epoxy Laminate Composites Modified with SiO2 Nanoparticles Fabricated by Resin Infusion
Open Access
- 31 January 2026
- journal article
- research article
- Published by MDPI AG in Lubricants
- Vol. 14 (2) , 65
Abstract
This work presents a study on the evaluation of the erosive wear behavior of laminated composites, manufactured using the vacuum-assisted resin infusion (VARI) method with a glass fiber-reinforced epoxy matrix modified with SiO2 nanoparticles (0.0, 1.5, and 3.0 wt.%). Results indicate that nanoparticle concentration and dispersion state critically influence the mechanical and tribological performance. The composite FG-1.5-SiO2 with 1.5 wt.% SiO2 exhibited optimal nanoparticle distribution, as confirmed by FTIR, GIXRD, and SEM analyses, with the lowest surface roughness (Ra = 0.215 μm), highest hardness (35.58 HV), and highest elastic modulus (19.66 GPa). These enhancements contributed to a 38% improvement in erosion rate compared to the unmodified laminated composite, with the lowest total mass loss (0.0261 mg) and erosion rate (2.3360 × 10−5 mg/g). Profilometry and SEM results revealed shallower wear depths and reduced matrix removal, indicating stronger fiber–matrix interface integrity. In contrast, the 3.0 wt.% SiO2 composite (FG-3-SiO2) suffered from nanoparticle agglomeration, which increased surface roughness, diminished mechanical properties, and reduced erosion resistance to levels comparable to the unreinforced material. The results indicate that homogeneous dispersion at an optimal concentration (1.5 wt.%) is crucial for improving erosion resistance, while agglomeration at higher concentrations negates the potential benefits of nanoparticle incorporation. These findings highlight the need to optimize nanoparticle dispersion for the development of fiberglass/epoxy composites with greater durability and erosion resistance in demanding applications.Keywords
All Related Versions
Funding Information
- Secretariat of Science, Humanities and Technology
- Innovation (before CONAHCyT) project (319941)
This publication has 57 references indexed in Scilit:
- Damage mechanism and residual tensile strength of CFRP laminates subjected to high-velocity sand erosionComposites Part B: Engineering, 2025
- Academic research for composite aerostructures - A personal perspectiveComposites Part B: Engineering, 2024
- Synthesis of SiO2-Nanoparticles from Rice Husk Ash and its Comparison with Commercial Amorphous Silica through Material CharacterizationSilicon, 2020
- Epoxy Polyamide Composites Reinforced with Silica Nanorods: Fabrication, Thermal and Morphological InvestigationsJournal of Inorganic and Organometallic Polymers and Materials, 2020
- An objective comparison of common vacuum assisted resin infusion processesComposites Part A: Applied Science and Manufacturing, 2019
- Mechanical properties and tribological performance of epoxy/Al2O3 nanocompositeCeramics International, 2018
- Efficiency of stress transfer between polymer matrix and nanoplatelets in clay/polymer nanocompositesApplied Clay Science, 2017
- Study of nanoparticles aggregation/agglomeration in polymer particulate nanocomposites by mechanical propertiesComposites Part A: Applied Science and Manufacturing, 2016
- Resin infusion analysis of nanoclay filled glass fiber laminatesComposites Part B: Engineering, 2014
- Synthesis and characterization of TiO2/SiO2 nano composites for solar cell applicationsApplied Nanoscience, 2012