EFFECTS OF DUCT BURNER ON BOTTOMING CYCLE IN A COMBINED CYCLE POWER PLANT
Open Access
- 20 November 2017
- journal article
- Published by Penerbit UTM Press in Jurnal Teknologi (Sciences & Engineering)
- Vol. 79 (7-3)
Abstract
In this study, thermodynamic modeling and exergoeconomic assessment of a Combined Cycle Power Plant (CCPP) with a Duct Burner (DB) was performed. Obtaining an optimum condition for the performance of a CCPP, using a DB after gas turbine was investigated by various researchers. DB is installed between gas turbine cycle and Rankine cycle of a CCPP to connect the gas turbine outlet to the Heat Recovery Steam Generator (HRSG) in order to produce steam for bottoming cycle. To find the irreversibility effect in each component of the bottoming cycle, a comprehensive parametric study is performed. In this regard, the effect of DB fuel flow rate on cost efficiency and economic of the bottoming cycle are investigated. To obtain a reasonable result, all the design parameters are kept constant while the DB fuel flow rate is varied. The results indicate that by increasing DB fuel flow rate, the investment cost and the efficiency of CCPP are increased. T-S diagram reveals that by using a DB, higher pressures steam in heat recovery steam generator has higher temperature while the low pressure is decreased. In addition, the exergy of flow gases in heat recovery steam generator increases. So, the exergy efficiency of the whole cycle was increased to around 6 percent, while the cost of the plant reduced by one percent.Keywords
This publication has 21 references indexed in Scilit:
- Energetic-environmental-economic assessment of the biogas system with three utilization pathways: Combined heat and power, biomethane and fuel cellBioresource Technology, 2016
- Energy, Exergy, Exergoeconomic and Environmental (4E) Optimization of a Large Steam Power Plant: A Case StudyIranian Journal of Science and Technology, Transactions of Mechanical Engineering, 2016
- Optimal Unit Sizing of Biogas-Fuelled Micro Gas Turbine Cogeneration Systems in a Sewage Treatment PlantEnergy Procedia, 2015
- Economic evaluation of biogas and natural gas co-firing in gas turbine combined heat and power systemsApplied Thermal Engineering, 2014
- Investigation of a gas turbine CHP system under the carbon price in Australia considering natural gas and biogas fuelsApplied Thermal Engineering, 2014
- Modelling and optimization of combined cycle power plant based on exergoeconomic and environmental analysesApplied Thermal Engineering, 2014
- Thermo-economic-environmental multiobjective optimization of a gas turbine power plant with preheater using evolutionary algorithmInternational Journal of Energy Research, 2011
- Thermal-economic multi-objective optimization of plate fin heat exchanger using genetic algorithmApplied Energy, 2010
- Economic assessment of biogas-to-electricity generation system with H2S removal by activated carbon in small pig farmApplied Energy, 2009
- The Exergy Method of Thermal Plant Analysis1985