Effect of compatibilizing agents on the physical properties of iPP/HDPE organoclay blends
Authors:
- Samia BoufassaSBSamia Boufassa
- R. DoufnouneRDR. Doufnoune
- Abdelhak HellatiAHAbdelhak Hellati
- Nacceredine HaddaouiNHNacceredine Haddaoui
- M. Esperanza CagiaoMCM. Esperanza Cagiao
- 1 October 2013
- journal article
- research article
- Published by Walter de Gruyter GmbH in Journal of Polymer Engineering
- Vol. 33 (7) , 589-598
Abstract
Blends of isotactic polypropylene (iPP) and high density polyethylene (HDPE), with and without compatibilizers and with different organoclay amounts (1%, 3%, and 5%), were systematically investigated to assess the effect of the additives on the crystallinity of the blends, as well as the correlation between the microhardness,Hand the Young’s modulusE. The compatibilizers used were: maleic anhydride grafted styrene ethylene butadiene styrene (SEBS-g-MAH), maleic anhydride grafted polyethylene (PE-g-MAH), maleic anhydride grafted polypropylene (PP-g-MAH), ethylene propylene diene monomer (EPDM), and maleic anhydride grafted EPDM (EPDM-g-MAH). The thermal properties and crystallization behavior were determined by differential scanning calorimetry (DSC) and wide angle X-ray scattering (WAXS). Macro- and micromechanical properties were also investigated. The results obtained showed that the addition of clay slightly increases the crystallinityαWAXSof the blends. However, the hardnessHdecreases enormously only by adding 1 wt% of clay. With higher clay amounts,Hincreases again. The relationship between the Young’s modulusEand the hardnessHfor all the studied blends was found to be somewhat higher than the one obtained for polyethylene (PE) samples with different morphologies.Keywords
This publication has 20 references indexed in Scilit:
- Understanding and controlling the structure of polypropylene/layered silicate nanocompositesJournal of Polymer Science Part B: Polymer Physics, 2008
- Preparation of polymer–clay nanocomposites and their propertiesAdvances in Polymer Technology, 2006
- Morphology and micromechanical properties of ethylene/1‐octene copolymers and their blends with high density polyethylenePolymers for Advanced Technologies, 2005
- Nanocomposites formed from linear low density polyethylene and organoclaysPolymer, 2004
- Relating microhardness to morphology in styrene/butadiene block copolymer/polystyrene blendsPolymer, 2004
- Micromechanical studies on binary and ternary blends of polyethylene, polypropylene, and polyamide 66: Influence of the compatibilizerInternational Journal of Polymeric Materials and Polymeric Biomaterials, 2003
- Influence of clay exfoliation on the physical properties of montmorillonite/polyethylene compositesPolymer, 2002
- Microhardness studies of chain-extended PE: III. Correlation with yield stress and elastic modulusPolymer, 2000
- Compatibilized linear low‐density polyethylene/isotactic polypropylene blends studied by positron annihilation lifetime spectroscopyPolymer Engineering & Science, 1995
- Rheological and mechanical properties of ternary blends of linear‐low‐density polyethylene/polypropylene/ethylene‐propylene block polymersPolymer Engineering & Science, 1984