High Thermoelectric Performance in PbSe–NaSbSe2 Alloys from Valence Band Convergence and Low Thermal Conductivity
Authors:
- Tyler J. SladeTSTyler J. Slade
- Trevor P. BaileyTBTrevor P. Bailey
- Jann A. GrovoguiJGJann A. Grovogui
- Xia HuaXHXia Hua
- Xiaomi ZhangXZXiaomi Zhang
- Jimmy Jiahong KuoJKJimmy Jiahong Kuo
- Ido HadarIHIdo Hadar
- G. Jeffrey SnyderGSG. Jeffrey Snyder
- Chris WolvertonCWChris Wolverton
- Vinayak P. DravidVDVinayak P. Dravid
- Ctirad UherCUCtirad Uher
- Mercouri G. KanatzidisMKMercouri G. Kanatzidis
- 1 July 2019
- journal article
- research article
- Published by Wiley in Advanced Energy Materials
- Vol. 9 (30)
Abstract
PbSe is an attractive thermoelectric material due to its favorable electronic structure, high melting point, and lower cost compared to PbTe. Herein, the hitherto unexplored alloys of PbSe with NaSbSe2 (NaPbmSbSem+2) are described and the most promising p‐type PbSe‐based thermoelectrics are found among them. Surprisingly, it is observed that below 500 K, NaPbmSbSem+2 exhibits unorthodox semiconducting‐like electrical conductivity, despite possessing degenerate carrier densities of ≈1020 cm−3. It is shown that the peculiar behavior derives from carrier scattering by the grain boundaries. It is further demonstrated that the high solubility of NaSbSe2 in PbSe augments both the thermoelectric properties while maintaining a rock salt structure. Namely, density functional theory calculations and photoemission spectroscopy demonstrate that introduction of NaSbSe2 lowers the energy separation between the L‐ and Σ‐valence bands and enhances the power factors under 700 K. The crystallographic disorder of Na+, Pb2+, and Sb3+ moreover provides exceptionally strong point defect phonon scattering yielding low lattice thermal conductivities of 1–0.55 W m‐1 K‐1 between 400 and 873 K without nanostructures. As a consequence, NaPb10SbSe12 achieves maximum ZT ≈1.4 near 900 K when optimally doped. More importantly, NaPb10SbSe12 maintains high ZT across a broad temperature range, giving an estimated record ZTavg of ≈0.64 between 400 and 873 K, a significant improvement over existing p‐type PbSe thermoelectrics.Keywords
Funding Information
- U.S. Department of Energy (DE‐SC0014520‐0003)
- Materials Research Science and Engineering Center, Harvard University (NSF DMR‐1720139)
- National Science Foundation (DGE‐1324585)
This publication has 71 references indexed in Scilit:
- Role of Sodium Doping in Lead Chalcogenide ThermoelectricsJournal of the American Chemical Society, 2013
- Band Engineering of Thermoelectric MaterialsAdvanced Materials, 2012
- Weak electron–phonon coupling contributing to high thermoelectric performance in n-type PbSeProceedings of the National Academy of Sciences, 2012
- Stabilizing the Optimal Carrier Concentration for High Thermoelectric EfficiencyAdvanced Materials, 2011
- Understanding Nanostructures in Thermoelectric Materials: An Electron Microscopy Study of AgPb18SbSe20 CrystalsChemistry of Materials, 2010
- Projector augmented-wave methodPhysical Review B, 1994
- Ab initiomolecular-dynamics simulation of the liquid-metal–amorphous-semiconductor transition in germaniumPhysical Review B, 1994
- Thermophysical properties of polycrystalline PbS, PbSe, and PbTe in the temperature range 300?700 KInternational Journal of Thermophysics, 1983
- Special points for Brillouin-zone integrationsPhysical Review B, 1976
- Self-Consistent Equations Including Exchange and Correlation EffectsPhysical Review B, 1965