20% Efficient Screen-Printed n-Type Solar Cells Using a Spin-On Source and Thermal Oxide/Silicon Nitride Passivation
Authors:
- 1 October 2011
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 1 (2) , 146-152
Abstract
N-type Si cells offer a compelling alternative to p-type cells to achieve high, stabilized cell efficiencies because they do not suffer from light-induced degradation. However, the most common dielectric materials that are used to passivate the n+ emitters of p-type cells-thermal SiO2 and SiNX-have historically provided poor passivation of the p+ emitters required for n-type cells. In this paper, we demonstrate that a thin thermal-SiO2/SiNX stack can, when appropriately fired, provide similar passivation on both p+ and n+ surfaces. Passivation studies on textured, SiO2/SiNX passivated p+-Si surfaces indicate that a high-temperature firing cycle is the most important step to achieving high-quality passivation and that the positive charge in the dielectric stack may have little detrimental effect on industrial-type, high surface concentration emitters. In addition, the suitability of spin-on boric acid sources for forming uniform, well-passivated p+ emitters on textured surfaces was studied. This passivation scheme and spin-on boron source were used to achieve 4-cm2 screen-printed n-type cells with efficiencies over 20% and open-circuit voltages up to 650 mV.Keywords
This publication has 22 references indexed in Scilit:
- The impact of cell design on light induced degradation in p-type silicon solar cells2011
- Practical challenges of achieving high efficiency boron back surface field solar cells2010
- Fabrication of 20 % efficient cells using spin-on based simultaneous diffusion and dielectric anneal2009
- Surface passivation of boron diffused emitters for high efficiency solar cells2008 33rd IEEE Photovolatic Specialists Conference, 2008
- Hydrogen diffusion in silicon from PECVD silicon nitride2008
- Excellent passivation of highly doped p-type Si surfaces by the negative-charge-dielectric Al2O3Applied Physics Letters, 2007
- Damage-Layer-Mediated H Diffusion During SiN:H Processing: A Comprehensive Model2006
- Structure and transformation of the metastable boron- and oxygen-related defect center in crystalline siliconPhysical Review B, 2004
- Passivated emitters in silicon solar cells2002
- Studies of diffused phosphorus emitters: saturation current, surface recombination velocity, and quantum efficiencyIEEE Transactions on Electron Devices, 1990