A Feasible Study on the Application of Cyclic Annealing Treatment for Functionality Improvement of 3D Printed PLA Parts
Open Access
- 27 January 2023
- journal article
- research article
- Published by Al-Kindi Center for Research and Development in Journal of Mechanical, Civil and Industrial Engineering
- Vol. 4 (1) , 50-56
Abstract
In the 3D printing of polymeric parts, the annealing cycle is a post-process method that allows different polymeric materials to enhance their mechanical and thermal properties and also eliminate their residual stresses. However, annealing has some drawbacks, such as producing induced shrinkage to the treated parts. In this study, a new technique named “cyclic annealing” is proposed to reduce shrinkage due to annealing treatment. By subsequent increasing and reduction of the temperature over and below the glass transition temperature instead of suddenly increasing the temperature to the target annealing temperature, a significant reduction of shrinkage was observed for the printed PLA parts. Various cylindrical shape samples with different infill densities (30%, 50%, 70%, and 100%) were examined at 70°C, 90°C, and 110°C annealing temperatures. Considerable reduction of shrinkage by up to 50% and improvement of the material strength were observed, which confirms the applicability of the proposed cyclic annealing method as an alternative to traditional polymer annealing for 3D printed materials.Keywords
This publication has 9 references indexed in Scilit:
- Using thermal annealing and salt remelting to increase tensile properties of 3D FDM printsEngineering Failure Analysis, 2022
- 3D printing of polymer composites: Materials, processes, and applicationsMatter, 2022
- Current status and future roles of additives in 3D printing—A perspectiveJournal of Vinyl and Additive Technology, 2022
- 3D Printing in medicine: Technology overview and drug delivery applicationsAnnals of 3D Printed Medicine, 2021
- A Review on Development of Bio-Inspired Implants Using 3D PrintingBiomimetics, 2021
- Investigating the Material Properties and Microstructural Changes of Fused Filament Fabricated PLA and Tough-PLA PartsPolymers, 2021
- Shape-Morphing Fibrous Hydrogel/Elastomer Bilayers Fabricated by a Combination of 3D Printing and Melt Electrowriting for Muscle Tissue RegenerationACS Applied Bio Materials, 2021
- Effect of heat treatment on mechanical properties of 3D printed polylactic acid partsMaterials Testing, 2021
- Enhancing the interlayer tensile strength of 3D printed short carbon fiber reinforced PETG and PLA composites via annealingAdditive Manufacturing, 2019