Modeling Of Polymer Melt Flow In The Annular Channel Of A Disk Extruder
Open Access
- 28 March 2023
- journal article
- research article
- Published by Ukrainian State University of Science and Technologies in Science and Transport Progress
- No. 1(101),p. 37-46
Abstract
Purpose. Polymer products are used in industry due to their performance properties. The homogeneity of the melt is essential for the quality of the final product. Uniform distribution of components and properties ensures homogeneity of the product's physical and mechanical characteristics. Insufficient homogeneity can lead to defects in the product. The homogenization zone plays an important role in ensuring a homogeneous melt. In a disc extruder, the homogenization zone consists of four consecutive channels. In order to describe the flow for the entire homogenization zone, it is necessary to model the first channel first. Therefore, the main purpose of this work is to model hydrodynamic and thermal processes during the flow of a non-Newtonian fluid in a straight annular channel in a non-isothermal regime, as well as to create a general procedure for further calculations for other channels. Methodology. The analysis of publications was carried out. The procedure for calculating the velocity and shear rate of the longitudinal and tangential melt flow, the effective melt viscosity, and the calculation of the melt temperature change along the length of the annular gap in an analytical form was developed. Findings. In accordance with the developed procedure, the values of tangential and longitudinal velocities and shear rates were calculated. The graphical dependences of the distribution of tangential and longitudinal velocities and shear velocities of the melt flow along the width of the annular channel, the distribution of pressure and the temperature of the polymer melt averaged over the width of the gap along the length of the annular channel are presented. Originality. In this work, a stationary flow in a straight annular channel was modeled for LDPE of the 15803-020 grade in a non-isothermal regime. A general procedure for further calculations for other channels of the homogenization zone has been developed. Practical value. The given calculation procedure can be applied to the following channels of the homogenization zone, which allows describing the melt flow for the entire homogenization zone.Keywords
This publication has 6 references indexed in Scilit:
- The Process of Melt Homogenization in a Metered-Discharge Disk ExtruderScience and Transport Progress, 2022
- Heat Transport in Rotating Annular Duct: A Short ReviewEnergies, 2022
- Enhancing Mixing and Thermal Management of Recycled Carbon Composite Systems by Torsion-Induced Phase-to-Phase Thermal and Molecular MobilityPolymers, 2020
- Dynamic modelling of die melt temperature profile in polymer extrusion2013
- Investigation of the temperature homogeneity of die melt flows in polymer extrusionPolymer Engineering & Science, 2013
- A review of heat transfer between concentric rotating cylinders with or without axial flowInternational Journal of Thermal Sciences, 2011