Influence of a Hot Extrusion with Rectangular‐Section on Mechanical Properties and Microstructure of 0.5 wt% Graphene Nanoplate‐Reinforced Aluminum Composites
Authors:
- 18 December 2020
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 23 (4)
Abstract
A hot extrusion process for obtaining rectangular cross‐sections is applied to a graphene nanoplate (GNP)‐reinforced aluminum (Al) composite (GNP/Al) composite. After extrusion, the GNP dispersion is more uniform and its layer number decreases, whereas the proportion of small grains increases; the composite and pure aluminum exhibit a typical extrusion texture. Distinct equiaxed grains, which are attributed to graphene presence, are visible on the composite section in the extrusion normal direction, whereas the pure aluminum presents spindle‐shaped grain in the same direction. Certain high‐disorientation angles are generated, indicating the occurrence of dynamic recrystallization during the extrusion process. The tensile strength of the GNP/Al composite is moderately improved (11.2%), whereas its plasticity increases insignificantly. This relative small enhancement is attributed to the relative small extrusion ratio. The amount of strength reinforcement (induced by hot extrusion) calculates by the shear lag model is in good agreement with the experimental results, indicating that the shear lag strengthening model can accurately predict the strengthening effect of the hot extrusion process.Keywords
Funding Information
- National Natural Science Foundation of China (51705295, 51778351)
- Natural Science Foundation of Shandong Province (ZR2014JL040, ZR2018MEE022)
This publication has 29 references indexed in Scilit:
- Fabrication and consolidation behavior of Al 6061 nanocomposite powders reinforced by multi-walled carbon nanotubesPowder Technology, 2014
- Enhancement of the mechanical properties of graphene–copper composites with graphene–nickel hybridsMaterials Science and Engineering: A, 2014
- Accumulative press bonding; a novel manufacturing process of nanostructured metal matrix compositesMaterials & Design (1980-2015), 2013
- Raman spectroscopy as a versatile tool for studying the properties of grapheneNature Nanotechnology, 2013
- Synergistic strengthening by load transfer mechanism and grain refinement of CNT/Al–Cu compositesCarbon, 2012
- A new method for determining dynamic grain structure evolution during hot aluminum extrusionJournal of Materials Processing Technology, 2012
- Particle effects on recrystallization in magnesium–manganese alloys: Particle pinningMaterials Science and Engineering: A, 2011
- An analysis of the factors affecting strengthening in carbon nanotube reinforced aluminum compositesCarbon, 2011
- Microstructure and mechanical properties of SiCp/AZ91 composite deformed through a combination of forging and extrusion processMaterials & Design (1980-2015), 2010
- Modeling of texture evolution in the deformation zone of second-phase particlesActa Materialia, 2009