Effect of calcination time on the adsorptive capacity of molybdenum oxides for the removal of methylene blue in aqueous solution
Authors:
- Jorge Fernandes FilhoJFJorge Fernandes Filho
- Samir Leite MathiasSMSamir Leite Mathias
- Henrique Solowej Medeiros LopesHLHenrique Solowej Medeiros Lopes
- Giovanni Miraveti CarrielloGCGiovanni Miraveti Carriello
- Marcus Felippe de Jesus BarrosMBMarcus Felippe de Jesus Barros
- Vagner Romito De MendonçaVMVagner Romito De Mendonça
- Aparecido Junior de MenezesAMAparecido Junior de Menezes
Open Access
- 20 May 2024
- journal article
- Published by Disciplinarum Scientia: Serie Ciencias Naturais e Tecnologicas in Disciplinarum Scientia - Ciências Naturais e Tecnológicas
- Vol. 25 (2) , 331-344
Abstract
The increasing industrialization process and the discharge of pollutants into water bodies have been concerns since the beginning of industrialization. To ensure safe access to water, new purification methodologies and stricter regulations are necessary. This study aims to develop materials for the removal of methylene blue (MB) dye in aqueous systems. Materials were synthesized through the oxidation of molybdenum disulfide (MoS₂) and subjected to different calcination times, seeking a balance between energy consumption and adsorption capacity. The elemental composition of the samples was analyzed by Scanning Electron Microscopy with Energy Dispersive X-ray Spectroscopy (SEM-EDS), X-ray Diffraction (XRD), and Fourier-Transform Infrared Spectroscopy (FTIR) revealed the transformation of MoS₂ to molybdenum trioxide (MoO3) proportional to the thermal treatment time. The kinetic analysis of MB adsorption revealed that the sample calcined for 300 minutes exhibited the highest efficiency in dye removal from the solution, with an adsorption capacity of 41.6 mg.g-1 after 300min. This capacity was significantly higher than that of the sample calcined for 30 minutes during the same period of time (18.6 mg.g-1), representing a 124% increase. Compared to the precursor material (6.60 mg.g-1), the improvement in adsorption capacity was even more expressive, with a 530% increase. Tests adsorption isotherms indicated that the maximum adsorption capacity of the sample calcined for 300 minutes was 379.0 mg.g-1. Equilibrium tests indicated that the maximum adsorption capacity of the sample calcined for 300 minutes was 379.0 mg.g-1. The greater dispersion in aqueous media of the calcined sample, compared to the others, is attributed to the presence of molybdenum oxide, favoring the adsorption of the dye onto the surface of the material formed.Keywords
This publication has 4 references indexed in Scilit:
- Adsorption isotherm models: Classification, physical meaning, application and solving methodChemosphere, 2020
- Fabrication of MoO3 Nanowire-based Membrane Devices for the Selective Adsorption of Cationic Dyes from Aqueous Solutions with High Performance and ReusabilityMicromachines, 2019
- Molybdenum Trioxide: Efficient Nanosorbent for Removal of Methylene Blue Dye from Aqueous SolutionsMolecules, 2018
- Removal of methylene blue from aqueous solution by graphene oxideJournal of Colloid and Interface Science, 2011