Influence of the welding current intensity and nitrogen content on the corrosion resistance of austenitic stainless steels
Authors:
- 18 July 2018
- journal article
- research article
- Published by Wiley in Materials and Corrosion
- Vol. 69 (12) , 1758-1769
Abstract
The resistance to pitting and intergranular corrosion of the welded joint of X5CrNi18‐10 austenitic stainless steel is analyzed in this paper. The resistance of the welded joint to intergranular corrosion does not depend on the nitrogen content in the shielding gas. It depends on the heat input into the welded joint, that is, on the welding current intensity. The resistance to pitting corrosion depends on the content of nitrogen in the shielding gas and on the welding current intensity. With the increase in the nitrogen content in the shielding gas, the resistance of the heat affected zone (HAZ) to pitting corrosion increases. The welding current intensity (heat input into the welded joint) shows two opposite effects. On the one hand, the increase of the heat input into the welded joint causes a more intensive precipitation of chromium carbides along the grain boundaries, which then leads to depletion in chromium of the grain boundary areas. The sensitization degree of the HAZ is thus increased and the formation of pits easier. On the other hand, with the increase in the welding current intensity, diffusion of nitrogen from the weld metal into the HAZ is facilitated, which contributes to the increased HAZ resistance to pitting corrosion. Possible mechanisms for increasing the HAZ resistance to pitting corrosion in the presence of nitrogen are also considered.Keywords
Funding Information
- Ministry of Education, Science and Technological Development of the Republic of Serbia (TR 34028, TR 35021)
This publication has 37 references indexed in Scilit:
- Novel strategies for assessing the pitting corrosion resistance of stainless steel surfacesMaterials and Corrosion, 2012
- Formation of M23C6-type precipitates and chromium-depleted zones in austenite stainless steelScripta Materialia, 2011
- Application of electrochemical methods for the investigation of intergranular corrosion welded joint austenitic stainless steel 19Cr-9NiHemijska industrija, 2011
- Evaluation of intergranular corrosion susceptibility of UNS S31803 duplex stainless steel with an optimized double loop electrochemical potentiokinetic reactivation methodElectrochimica Acta, 2010
- Recent developments in stainless steelsMaterials Science and Engineering: R: Reports, 2009
- Sensitisation identification of stainless steel to intergranular stress corrosion cracking by atomic force microscopyMaterials Letters, 2008
- Effect of nitrogen on the corrosion behavior of austenitic stainless steel in chloride solutionsMaterials Letters, 2005
- Influence of heat flux and surface temperature on the intergranular corrosion of stainless steelMaterials and Corrosion, 2005
- Characterisation and corrosion of spot welds of austenitic stainless steelsMaterials and Corrosion, 2004
- Initiation of Corrosion Pits at Inclusions on 304 Stainless SteelJournal of the Electrochemical Society, 1995