On the influence of state selection on mass conservation in dynamic vapour compression cycle models
Open Access
- 27 March 2017
- journal article
- research article
- Published by Taylor & Francis in Mathematical and Computer Modelling of Dynamical Systems
- Vol. 1, 1-22
Abstract
Many dynamic models of vapour compression systems experience nonphysical variations in the total refrigerant mass contained in the system when common modelling approaches are used. Rather than using the traditional state variables of pressure and specific enthalpy, the use of density as a state variable can eliminate these variations. The reasons for these variations are explained, and a set of test models is developed to study the effect of the state variable selection on the overall system charge. Results from both a simplified cycle model and a realistic air-source heat pump model indicate that this alternative approach has significant benefits for maintaining a fixed mass of refrigerant in the cycle.Keywords
This publication has 8 references indexed in Scilit:
- A comparison of transient heat pump cycle models using alternative flow descriptionsScience and Technology for the Built Environment, 2015
- Recent advances in dynamic modeling of HVAC equipment. Part 1: Equipment modelingHVAC&R Research, 2014
- Recent advances in dynamic modeling of HVAC equipment. Part 2: Modelica-based modelingHVAC&R Research, 2014
- Partial derivatives of thermodynamic state properties for dynamic simulationEnvironmental Earth Sciences, 2013
- Chattering in dynamic mathematical two-phase flow modelsApplied Mathematical Modelling, 2012
- An intrinsically mass conservative switched evaporator model adopting the moving-boundary methodInternational Journal of Refrigeration, 2012
- Influence of the source and sink temperatures on the optimal refrigerant charge of a water-to-water heat pumpInternational Journal of Refrigeration, 2011
- Calculation of Fin Efficiency for Wet and Dry FinsHVAC&R Research, 1996