Enhancement of Cd‐Free All‐Dry‐Processed Cu(In1‐x,Gax)Se2 Thin‐Film Solar Cells by Simultaneous Adoption of an Enlarged Bandgap Absorber and Tunable Bandgap Zn1‐xMgxO Buffer
Open Access
- 14 August 2024
- journal article
- research article
- Published by Wiley in Energy & Environmental Materials
- Vol. 8 (1)
Abstract
Attempts to remove environmentally harmful materials in mass production industries are always a major issue and draw attention if the substitution guarantees a chance to lower fabrication cost and to improve device performance, as in a wide bandgap Zn1‐xMgxO (ZMO) to replace the CdS buffer in Cu(In1‐x,Gax)Se2 (CIGSe) thin‐film solar cell structure. ZMO is one of the candidates for the buffer material in CIGSe thin‐film solar cells with a wide and controllable bandgap depending on the Mg content, which can be helpful in attaining a suitable conduction band offset. Hence, compared to the fixed and limited bandgap of a CdS buffer, a ZMO buffer may provide advantages in Voc and Jsc based on its controllable and wide bandgap, even with a relatively wider bandgap CIGSe thin‐film solar cell. In addition, to solve problems with the defect sites at the ZMO/CIGSe junction interface, a few‐nanometer ZnS layer is employed for heterojunction interface passivation, forming a ZMO/ZnS buffer structure by atomic layer deposition (ALD). Finally, a Cd‐free all‐dry‐processed CIGSe solar cell with a wider bandgap (1.25 eV) and ALD‐grown buffer structure exhibited the best power conversion efficiency of 19.1%, which exhibited a higher performance than the CdS counterpart.Keywords
Funding Information
- National Research Foundation of Korea (2022M3J1A1063019)
- Korea Institute of Energy Research (C4‐2412, C4‐2413)
This publication has 58 references indexed in Scilit:
- Effects of Ammonia‐Induced Surface Modification of Cu(In,Ga)Se2 on High‐Efficiency Zn(O,S)‐Based Cu(In,Ga)Se2 Solar CellsSolar RRL, 2018
- Band gap engineering of atomic layer deposited ZnxSn1‐xO buffer for efficient Cu(In,Ga)Se2 solar cellProgress in Photovoltaics: Research and Applications, 2018
- Sputtered Zn(O,S) buffer layers for CIGS solar modules—from lab to pilot productionProgress in Photovoltaics: Research and Applications, 2017
- Impact of oxygen concentration during the deposition of window layers on lowering the metastability effects in Cu(In,Ga)Se2/CBD Zn(S,O) based solar cellProgress in Photovoltaics: Research and Applications, 2015
- Minimizing metastabilities in Cu(In,Ga)Se2/(CBD)Zn(S,O,OH)/i‐ZnO‐based solar cellsProgress in Photovoltaics: Research and Applications, 2014
- Defects in Cu(In,Ga)Se2 Chalcopyrite Semiconductors: A Comparative Study of Material Properties, Defect States, and Photovoltaic PerformanceAdvanced Energy Materials, 2011
- Temperature‐dependent current‐voltage and lightsoaking measurements on Cu(In,Ga)Se2 solar cells with ALD‐Zn1‐xMgxO buffer layersProgress in Photovoltaics: Research and Applications, 2009
- The Zn(S,O,OH)/ZnMgO buffer in thin‐film Cu(In,Ga)(Se,S)2‐based solar cells part II: Magnetron sputtering of the ZnMgO buffer layer for in‐line co‐evaporated Cu(In,Ga)Se2 solar cellsProgress in Photovoltaics: Research and Applications, 2009
- Atomic layer deposition of Zn1−xMgxO buffer layers for Cu(In,Ga)Se2 solar cellsProgress in Photovoltaics: Research and Applications, 2006
- Self-consistent electronic structures of MgO and SrOSolid State Communications, 1985