Energy transfer and stress wave propagation during SPT through energy measurement and PIV
- 1 April 2025
- journal article
- research article
- Published by Emerald Publishing in Proceedings of the Institution of Civil Engineers - Geotechnical Engineering
- Vol. 178 (2) , 195-207
Abstract
The blow counts in standard penetration tests (SPTs) require suitable corrections to account for energy losses. Over 4000 energy measurements collected from four test sites across Hong Kong were collected and analysed in this study. On average, for all instrumented hammer blows, approximately 62% of the theoretical hammer potential energy was transferred to the drill rod assembly. Using high-speed camera imagery and particle image velocimetry (PIV), the detailed mechanism of stress wave propagation was visualised and assessed. This revealed new details and allowed nuances in the results of routine energy measurements to be interpreted in new light. The results showed that the initial compressive wave is reflected as a tensile wave for low end-restraint at the SPT sampler and as a second compressive wave for high end-restraint. Commonly observed discrepancies between theoretical and measured speeds of wave propagation were explored. Energy loss arises from friction during free-fall of the hammer, at the anvil and from other sources such as the horizontal motion of the hammer–anvil system. The proportion of each major source of energy loss was quantified.Keywords
This publication has 11 references indexed in Scilit:
- Energy Measurement in Standard Penetration TestsSustainability, 2023
- SPT Energy Measurements: Manual vs. Automatic Hammer ReleaseGeotechnical and Geological Engineering, 2016
- AvoPlot: An extensible scientific plotting tool based on matplotlibJournal of Open Research Software, 2014
- SPT Hammer Energy Ratio versus Drop HeightJournal of Geotechnical and Geoenvironmental Engineering, 2008
- SPT Dynamic Analysis and MeasurementsJournal of Geotechnical and Geoenvironmental Engineering, 1997
- Standard penetration test procedures and the effects in sands of overburden pressure, relative density, particle size, ageing and overconsolidationGéotechnique, 1986
- Influence of SPT Procedures in Soil Liquefaction Resistance EvaluationsJournal of Geotechnical Engineering, 1985
- A Field Study of an Automatic SPT Hammer SystemGeotechnical Testing Journal, 1984
- Energy Dynamics of SPTJournal of the Geotechnical Engineering Division, 1979
- Velocity Measurement of Free-Fall SPT HammerJournal of the Geotechnical Engineering Division, 1979