Effect of Geometrical Parameters of Microscale Particles on Particle-Stimulated Nucleation and Recrystallization Texture of Al-Si-Mg-Cu-Based Alloy Sheets
Open Access
Abstract
The effects of the shapes (needle and round) and volume fractions (low and high) of microscale particles in Al-Si-Mg-Cu-based alloys on recrystallization behavior, texture evolution, mechanical properties, and formability are investigated. The recrystallized grain size decreases as the size and volume fraction of the particles decrease and increase, respectively, regardless of the particle shape. The investigated alloys with a relatively low volume fraction of 0.7 to 2.4 vol.% exhibit higher efficiency particle-stimulated nucleation (PSN) than alloys with a high volume fraction of 6.0 to 21.0 vol.%. This is because the interaction between the particles and dislocations cannot be greatly promoted when the volume fraction of the particles is large enough to form agglomerates. The sheets with round-shaped particles exhibit higher yield strength (YS) and elongation (EL) than sheets with needle-shaped particles. The improvement in YS is due to the combined effects of grain refinement and particle strengthening, and the EL is improved by reducing the probability of cracking at the tips of round-shaped particles. The sheets with round-shaped particles exhibit relatively higher average plastic strain ratio () and planar anisotropy (∆r) than the sheets with needle-shaped particles, owing to the development of Goss {110} or rotated-Goss {110} orientations.
Keywords
Funding Information
- Korean Ministry of Trade, Industry and Energy (MOTIE) (P0002019)
- Korea Institute for Advancement of Technology (P0002019)
This publication has 43 references indexed in Scilit:
- Modeling of texture evolution in the deformation zone of second-phase particlesActa Materialia, 2009
- Microstructural and crystallographic aspects of conventional and asymmetric rolling processesActa Materialia, 2008
- Effect of hot and cold deformation on the recrystallization texture of continuous cast AA 5052 aluminum alloyScripta Materialia, 2005
- Plastic anisotropy and texture evolution during tensile testing of extruded aluminium profilesModelling and Simulation in Materials Science and Engineering, 2005
- Microstructure and wear behaviour of aluminium alloys containing embedded nanoscaled lead dispersoidsActa Materialia, 2004
- On the relationship between microstructure, strength and toughness in AA7050 aluminum alloyMaterials Science and Engineering: A, 2003
- A Model of the β-AlFeSi to α-Al(FeMn)Si Transformation in Al-Mg-Si AlloysMATERIALS TRANSACTIONS, 2003
- Texture control by thermomechanical processing of AA6xxx Al–Mg–Si sheet alloys for automotive applications—a reviewMaterials Science and Engineering: A, 2002
- Texture analysis of the transition from slip to grain boundary sliding in a discontinuously recrystallized superplastic aluminum alloyActa Materialia, 2001
- Current issues in recrystallization: a reviewMaterials Science and Engineering: A, 1997