Single-Grating Monolithic Spatial Heterodyne Raman Spectrometer: An Investigation on the Effects of Detector Selection
- 6 October 2023
- journal article
- research article
- Published by SAGE Publications in Applied Spectroscopy
- Vol. 77 (12) , 1411-1423
Abstract
Spatial heterodyne Raman spectrometers (SHRSs) are modified forms of Michelson interferometers, except the mirrors in a Michelson interferometer are replaced with stationary diffraction gratings. This design removes the need for an entrance slit, as is the case in a dispersive spectrometer, and removes the need to scan the spectrum by using a moving mirror in a modern Michelson interferometer. In previous studies, various SHRS variants, such as free-standing two-grating SHRS, single-grating SHRS (1g-SHRS), monolithic SHRS (mSHRS), and single-grating mSHRS (1g-mSHRS), have been evaluated. However, the present study exclusively focuses on the 1g-mSHRS configuration. The 1g-mSHRS and 1g-SHRS increase the spectral range at fixed grating line density while trading off spectral resolution and resolving power. The mSHRS benefits from increased rigidity, lack of moving parts, and reduced footprint. In this study, we investigate how the choice of detector impacts the performance of the 1g-mSHRS system, with a specific focus on evaluating the performance of three types of cameras: charged-coupled device (CCD), intensified CCD (ICCD), and complementary metal–oxide–semiconductor (CMOS) cameras. These systems were evaluated using geological, organic, and inorganic samples using a 532 nm continuous wave laser for the CMOS and CCD cameras, and a 532 nm neodymium-doped yttrium aluminum garnet pulsed laser for the ICCD camera. The footprint of the 1g-mSHRS was 3.5 × 3.5 × 2.5 cm 3 with a mass of 272 g or 80 g, depending on whether the monolith housing is included or not. We found that increasing the number of pixels utilized along the x-axis of the camera increases fringe visibility (FV) and optimizes the resolution (by capturing the entirety of the grating and magnifying the fringes). The number of pixels utilized in the y-axis, chip size, and dimensions, affect the signal-to-noise ratio of the systems. Additionally, we discuss the effect of pixel pitch on the recovery of Fizeau fringes, including the relationship between the Nyquist frequency, aliasing, and FV.Keywords
Funding Information
- Aeronautics Research Mission Directorate (80NSSC19K1024)
- Division of Ocean Sciences (OCE-1829333)
This publication has 41 references indexed in Scilit:
- Raman Spectroscopy Using a Spatial Heterodyne Spectrometer: Proof of ConceptApplied Spectroscopy, 2011
- Differences between Bond Lengths in Biogenic and Geological CalciteCrystal Growth & Design, 2010
- The rheology of cryovolcanic slurries: Motivation and phenomenology of methanol-water slurries with implications for TitanIcarus, 2009
- Long-wave IR sensing using spatial heterodyne spectroscopySPIE Newsroom, 2009
- Dolomite Mountains and the origin of the dolomite rock of which they mainly consist: historical developments and new perspectivesSedimentology, 2008
- Quantitative Raman Reaction Monitoring Using the Solvent as Internal StandardAnalytical Chemistry, 2005
- Raman spectroscopy for mineral identification and quantification for in situ planetary surface analysis: A point count methodJournal of Geophysical Research, 1997
- Spatial heterodyne spectroscopy for the exploration of diffuse interstellar emission lines at far-ultraviolet wavelengthsThe Astrophysical Journal, 1992
- Spectromètre interférentiel à sélection par l'amplitude de modulationJournal de Physique et le Radium, 1958
- A New Type of Secondary RadiationNature, 1928