Synthesis of fuel oil and carbon nanotubes in an autoclave using plastic waste as precursor
- 7 October 2016
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 32 (5) , 495-500
Abstract
In this study, the synthesis of fuel oil and carbon nanotubes (CNTs) using waste plastic in a batch pyrolysis reactor of 750 mL capacity was carried out. Density, calorific values and FTIR spectroscopy confirmed the formation of fuel oil. The calorific value of oil was higher than the energy needed for pyrolysis process. The same reactor was used as an autoclave for the synthesis of CNTs. SEM and TEM results showed that carbon nanotubes of 40–60 nm diameters were grown on Ni/Mo/MgO catalyst. CNT yield was around 3.2 g of CNTs per 6 g of PP. The purity of CNTs was investigated by thermogravimetric analysis (TGA). The present study proposes a feasible process to convert plastic waste into furnace oil by rapid pyrolysis and synthesis of CNTs.Keywords
Funding Information
- Anusandhan National Research Foundation (SB/FTP/ETA-0235/2013)
This publication has 31 references indexed in Scilit:
- Turning refuse plastic into multi-walled carbon nanotube forestScience and Technology of Advanced Materials, 2012
- Feedstock recycling of waste polymeric materialJournal of Material Cycles and Waste Management, 2011
- Catalytic pyrolysis of polypropylene to synthesize carbon nanotubes and hydrogen through a two-stage processPolymer Degradation and Stability, 2011
- Synthesis of carbon nanofibres over nanoporous Ni–MgO catalyst: influence of the bimetallic Ni–(Cu, Co, Mo) MgO catalystsJournal of Experimental Nanoscience, 2011
- Pyrolysis–gasification of plastics, mixed plastics and real-world plastic waste with and without Ni–Mg–Al catalystFuel, 2010
- Development of Catalyst Free Carbon Nanotubes from Coal and Waste PlasticsFullerenes, Nanotubes and Carbon Nanostructures, 2009
- Sintering Process and Mechanical Property of MWCNTs/HDPE Bulk CompositePolymer-Plastics Technology and Engineering, 2009
- Aromatization of waste polyolefin pyrolysate over H-ZSM-5 zeolite-supported gallium oxide catalystsJournal of Material Cycles and Waste Management, 2008
- Introduction to Feedstock Recycling of Plastics2006
- Catalytic Functions of Mo/Ni/MgO in the Synthesis of Thin Carbon NanotubesThe Journal of Physical Chemistry B, 2005