Multi-objective Optimization of Non-circular Gear Through Orthogonal Array and Fuzzy Comprehensive Evaluation Method in WEDM
Authors:
- 6 February 2023
- journal article
- research article
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 48 (9) , 11973-11988
Abstract
No abstract availableKeywords
Funding Information
- National Defense Basic Scientific Research Program of China (JCKY2019427D002)
This publication has 45 references indexed in Scilit:
- An experimental study for multi-pass cutting operation in wire electrical discharge machining of WC-5.3% Co compositeThe International Journal of Advanced Manufacturing Technology, 2014
- Simultaneous optimization of WEDM responses using grey relational analysis coupled with genetic algorithm while machining EN 353The International Journal of Advanced Manufacturing Technology, 2014
- Seismic liquefaction potential assessed by fuzzy comprehensive evaluation methodNatural Hazards, 2013
- Application of Taguchi, ANFIS and grey relational analysis for studying, modeling and optimization of wire EDM process while using gaseous mediaThe International Journal of Advanced Manufacturing Technology, 2013
- Parametric study along with selection of optimal solutions in dry wire cut machining of cemented tungsten carbide (WC-Co)Journal of Manufacturing Processes, 2013
- Experimental investigation, intelligent modeling and multi-characteristics optimization of dry WEDM process of Al–SiC metal matrix compositeJournal of Manufacturing Processes, 2013
- Surface crack susceptibility of electrodischarge-machined steel surfacesThe International Journal of Advanced Manufacturing Technology, 2011
- Fuzzy Modeling and Analysis of Machining Parameters in Machining Titanium AlloyMaterials and Manufacturing Processes, 2008
- Electrical Discharge Machining (EDM) Characteristics Associated with Electrical Discharge Energy on Machining of Cemented Tungsten CarbideMaterials and Manufacturing Processes, 2008
- A study on kerf and material removal rate in wire electrical discharge machining based on Taguchi methodJournal of Materials Processing Technology, 2004