Abstract
A series of laboratory experiments were conducted to investigate the influence of overburden and in-situ stresses on non-Darcy gas flow behavior in Dakota sandstone. Nitrogen was flooded through cylindrical core in a triaxial core holder under specific condition of temperature at 100°F, with core outlet pore pressure at 500 psi, axial and radial stress from 2,000 to 10,000 psi, and. nitrogen reservoir pump pressure at 2,000 psi with pump flow rates from 25 to 10,000 cc/hr at 80°F. Permeability and non-Darcy coefficient were determined using Forchheimer's method. It was found that with the increase of overburden and in-situ stresses, permeability decreases while non-Darcy flow coefficient increases. Average effective normal stress and shear stress were used to quantitatively express the influence of overburden and in-situ stresses. It was found that average effective normal stress has a good linear relationship with both permeability and non-Darcy flow coefficient. In contrast, average shear stress did not appear to influence the permeability and non-Darcy coefficient. Introduction Darcy's law is widely used to describe the fluid flow though porous media in the petroleum industry and other disciplines. This law is based on experimental observations of fluid flow through porous media under laminar conditions, that is, under low flow velocity. But, in the near wellbore region, fluid velocity can be very high due to the high pressure gradient. Forchheimer1 noticed that at high velocity in porous media, the pressure drop is higher than predicted by Darcy's law. Non-linear terms of second and third power of the fluid velocity were added to Darcy's law to correlate the pressure drop and the flow velocity. Later Green and Duwez2 analytically derived the one-dimensional differential form of Forchheimer's equation as: They also determined the non-Darcy flow coefficient, ß for gas through sintered porous media. Cornell and Katz3 extended Green and Duwez's work2 to consolidated rocks, and established the widely-used method of determining permeability, k, and non-Darcy flow coefficient, ß from experimental data. Since then, considerable effort has been expended to address non-Darcy behavior in porous media. Several papers have presented very good reviews from different aspects on research about non-Darcy behavior of fluid flow through porous media.4-8 Several issues still remain to be addressed related to the experimental research on overburden and in-situ stress effects on non-Darcy behavior of gas flow through porous media. It has been noted that the Klinkenberg effect exists in non-Darcy flow if the average pore pressure is not sufficiently high, but the Forchheimer equation does not account for this effect.5 The stress effect on permeability under Darcy flow conditions has been investigated extensively.9-12 Several studies have investigated the effect of overburden pressures on the non-Darcy flow coefficient.5,13 However, quantitative equations were not generated, and those experiments were conducted under hydrostatic overburden pressures; which are usually different from the natural stress distribution in the near- wellbore region.14 A recent paper reported the efforts of measuring the non-Darcy coefficient under in-situ reservoir conditions using a triaxial set-up.15 However, the permeability was determined using Darcy's law and the non-Darcy coefficient using the Forchheimer's equation; an inherent conflict. This mixing of terms seems common, that is the permeability in the correlations between the non-Darcy flow coefficient and other rock properties (mainly permeability and porosity) are determined using Darcy's law.7-8,16