ZZZhengwen Zeng

Zhengwen Zeng

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Zhengwen Zeng has a total of 6 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Top Cited Papers

    A Criterion for Non-Darcy Flow in Porous Media

    by Zhengwen Zeng, Reid Grigg


  • IMPROVING CO2 EFFICIENCY FOR RECOVERING OIL IN HETEROGENEOUS RESERVOIRS

    by Reid B. Grigg, Robert K. Svec, Zhengwen Zeng, Baojun Bai, Yi Liu

    The third annual report of ''Improving CO{sub 2} Efficiency for Recovery Oil in Heterogeneous Reservoirs'' presents results of laboratory studies with related analytical models for improved oil recovery. All studies were designed to optimize utilization and extend the practice of CO{sub 2} flooding to a wider range of reservoirs. Chapter 1 describes the behavior at low concentrations of the surfactant Chaser International CD1045{trademark} (CD) versus different salinity, pressure and temperature. Results of studies on the effects of pH and polymer (hydrolyzed polyacrylamide?HPAM) and CO{sub 2} foam stability after adsorption in the core are also reported. Calcium lignosulfonate (CLS) transport mechanisms through sandstone, description of the adsorption of CD and CD/CLS onto three porous media (sandstone, limestone and dolomite) and five minerals, and the effect of adsorption on foam stability are also reported. In Chapter 2, the adsorption kinetics of CLS in porous Berea sandstone and non-porous minerals are compared by monitoring adsorption density change with time. Results show that adsorption requires a much longer time for the porous versus non-porous medium. CLS adsorption onto sandstone can be divided into three regions: adsorption controlled by dispersion, adsorption controlled by diffusion and adsorption equilibrium. NaI tracer used to characterize the sandstone hadmore » similar trends to earlier results for the CLS desorption process, suggesting a dual porosity model to simulate flow through Berea sandstone. The kinetics and equilibrium test for CD adsorption onto five non-porous minerals and three porous media are reported in Chapter 3. CD adsorption and desorption onto non-porous minerals can be established in less than one hour with adsorption densities ranging from 0.4 to 1.2 mg of CD per g of mineral in decreasing order of montmorillonite, dolomite, kaolinite, silica and calcite. The surfactant adsorption onto three porous media takes much longer than one hour, with Berea sandstone requiring the longest time. In Chapter 4, comparisons of static adsorption of CLS, CD, and CLS/CD mixtures onto five pure minerals showed that the presence of CLS decreased the adsorption of CD onto the five minerals by 20 to 70%. Dynamic CLS/CD mixture adsorption tests onto Berea sandstone and Indian limestone cores showed that competitive adsorption between CD and CLS generally takes several days to reach equilibrium. Foam stability and interfacial tension tests on both injected and effluent samples were performed which showed that both foam stability and IFT decreased due to adsorption. Also it appears that there is a chromatographic effect on the surfactants in flow through porous media. Progress was realized in developing general equations for stress sensitivity on non-Darcy parameters (permeability and non-Darcy coefficient), and the multiphase flow induced by a high flow rate was confirmed as a mechanism for injectivity loss in CO{sub 2} flooding. In Chapter 5, a general equation is defined based on 60 general equations of permeability stress sensitivity and non-Darcy coefficient stress sensitivity and definitions of nominal permeability, nominal non-Darcy coefficient, permeability stress sensitivity, and non-Darcy coefficient stress sensitivity. The equations of stress sensitivity are independent of pressure, temperature, and rock properties and existing empirical correlations of the nominal permeability and nominal non-Darcy coefficient can be used when laboratory data are not available. This provides a tool to quantify the change of permeability and non-Darcy coefficient due to change of effective stress resulted from reservoir injection and/or production. « less

  • IMPROVING CO2 EFFICIENCY FOR RECOVERING OIL IN HETEROGENEOUS RESERVOIRS

    by Reid B. Grigg, Robert K. Svec, Zheng-Wen Zeng, Liu Yi, Baojun Bai

    A three-year contract for the project, DOE Contract No. DE-FG26-01BC15364, ''Improving CO{sub 2} Efficiency for Recovering Oil in Heterogeneous Reservoirs'', was started on September 28, 2001. This project examines three major areas in which CO{sub 2} flooding can be improved: fluid and matrix interactions, conformance control/sweep efficiency, and reservoir simulation for improved oil recovery. The project has received a one-year, no-cost extension to September 27, 2005. During this extra time additional deliverables will be (1) the version of MASTER that has been debugged and a foam option added for CO{sub 2} mobility control and (2) adsorption/desorption data on pure component minerals common in reservoir rock that will be used to improve predictions of chemical loss to adsorption in reservoirs. This report discusses the activity during the six-month period covering October 1, 2003 through March 31, 2004 that comprises the first and second fiscal quarters of the project's third year. During this period of the project several areas have advanced: reservoir fluid/rock interactions and their relationships to changing injectivity, and surfactant adsorption on quarried core and pure component granules, foam stability, and high flow rate effects. Presentations and papers included: a papers covered in a previous report was presented at themore » fall SPE ATCE in Denver in October 2003, a presentation at the Southwest ACS meeting in Oklahoma City, presentation on CO{sub 2} flood basic behavior at the Midland Annual CO{sub 2} Conference December 2003; two papers prepared for the biannual SPE/DOE Symposium on IOR, Tulsa, April 2004; one paper accepted for the fall 2004 SPE ATCE in Houston; and a paper submitted to an international journal Journal of Colloid and Interface Science which is being revised after peer review. « less

  • Experimental Study of Overburden and Stress Influence on Non-Darcy Gas Flow in Dakota Sandstone

    by Zhengwen Zeng, Reid Grigg, Sukesh Ganda

    A series of laboratory experiments were conducted to investigate the influence of overburden and in-situ stresses on non-Darcy gas flow behavior in Dakota sandstone. Nitrogen was flooded through cylindrical core in a triaxial core holder under specific condition of temperature at 100°F, with core outlet pore pressure at 500 psi, axial and radial stress from 2,000 to 10,000 psi, and. nitrogen reservoir pump pressure at 2,000 psi with pump flow rates from 25 to 10,000 cc/hr at 80°F. Permeability and non-Darcy coefficient were determined using Forchheimer's method. It was found that with the increase of overburden and in-situ stresses, permeability decreases while non-Darcy flow coefficient increases. Average effective normal stress and shear stress were used to quantitatively express the influence of overburden and in-situ stresses. It was found that average effective normal stress has a good linear relationship with both permeability and non-Darcy flow coefficient. In contrast, average shear stress did not appear to influence the permeability and non-Darcy coefficient. Introduction Darcy's law is widely used to describe the fluid flow though porous media in the petroleum industry and other disciplines. This law is based on experimental observations of fluid flow through porous media under laminar conditions, that is, under low flow velocity. But, in the near wellbore region, fluid velocity can be very high due to the high pressure gradient. Forchheimer1 noticed that at high velocity in porous media, the pressure drop is higher than predicted by Darcy's law. Non-linear terms of second and third power of the fluid velocity were added to Darcy's law to correlate the pressure drop and the flow velocity. Later Green and Duwez2 analytically derived the one-dimensional differential form of Forchheimer's equation as: They also determined the non-Darcy flow coefficient, ß for gas through sintered porous media. Cornell and Katz3 extended Green and Duwez's work2 to consolidated rocks, and established the widely-used method of determining permeability, k, and non-Darcy flow coefficient, ß from experimental data. Since then, considerable effort has been expended to address non-Darcy behavior in porous media. Several papers have presented very good reviews from different aspects on research about non-Darcy behavior of fluid flow through porous media.4-8 Several issues still remain to be addressed related to the experimental research on overburden and in-situ stress effects on non-Darcy behavior of gas flow through porous media. It has been noted that the Klinkenberg effect exists in non-Darcy flow if the average pore pressure is not sufficiently high, but the Forchheimer equation does not account for this effect.5 The stress effect on permeability under Darcy flow conditions has been investigated extensively.9-12 Several studies have investigated the effect of overburden pressures on the non-Darcy flow coefficient.5,13 However, quantitative equations were not generated, and those experiments were conducted under hydrostatic overburden pressures; which are usually different from the natural stress distribution in the near- wellbore region.14 A recent paper reported the efforts of measuring the non-Darcy coefficient under in-situ reservoir conditions using a triaxial set-up.15 However, the permeability was determined using Darcy's law and the non-Darcy coefficient using the Forchheimer's equation; an inherent conflict. This mixing of terms seems common, that is the permeability in the correlations between the non-Darcy flow coefficient and other rock properties (mainly permeability and porosity) are determined using Darcy's law.7-8,16

  • IMPROVING CO2 EFFICIENCY FOR RECOVERING OIL IN HETEROGENEOUS RESERVOIRS

    by Reid B. Grigg, Robert K. Svec, Zheng-Wen Zeng, Liu Yi, Baojun Bai

    A three-year contract for the project, DOE Contract No. DE-FG26-01BC15364, ''Improving CO{sub 2} Efficiency for Recovering Oil in Heterogeneous Reservoirs,'' was awarded and started on September 28, 2001. This project examines three major areas in which CO2 flooding can be improved: fluid and matrix interactions, conformance control/sweep efficiency, and reservoir simulation for improved oil recovery. This report discusses the activity during the six-month period covering October 1, 2002 through March 31, 2003 that covers the first and second fiscal quarters of the project's second year. During these two quarters of the project we have been working in several areas: reservoir fluid/rock interactions and their relationships to changing injectivity, and surfactant adsorption on quarried core and pure component granules, foam stability, and high flow rate effects. We also had a very productive project review in Midland, Texas. A paper on CO{sub 2}-brine-reservoir rock interaction was presented and included in the proceedings of the SPE International Symposium on Oilfield Chemistry, Houston, 5-8 February, 2003. Papers have been accepted for the Second Annual Conference on Carbon Sequestration in Alexandria, VA in May, the Society of Core Analysis meeting in Pau, France in September, and two papers for the SPE Annual Meeting in Denver,more » CO in October. « less