A Fully 3D-Printable Pull-Off Fixture for Adhesion Testing of FDM Prints on Textile Substrates
Open Access
Abstract
Adhesion between fused deposition modelling (FDM) printed polymers and textile substrates is critical for durable printed-on-textile hybrids. Since no dedicated test standard exists for additively manufactured textile interfaces, many studies use T-peel methods adapted from adhesive-bond standards. However, printed-on-textile joints are often governed by polymer penetration into the fabric and mechanical interlocking, rather than by a discrete adhesive layer. This work evaluates a fixture-based perpendicular (normal-separation) tensile method, using a circular dolly printed directly onto a cotton plain-weave substrate and a fully 3D-printable, threaded, self-aligning clamping assembly. Three representative filaments, namely polyethylene terephthalate glycol-modified (PETG), polylactic acid (PLA), and thermoplastic polyurethane (TPU), were tested using both the proposed pull-off method and an ISO 11339-type T-peel benchmark, with n = 8 specimens per polymer. The perpendicular method produced complete datasets for all polymers and clearly differentiated adhesion performance (TPU > PLA > PETG). In contrast, for T-peel, the standard evaluation window (25–125 mm) was completed for all PETG specimens but only for a subset of PLA specimens and a single TPU specimen. In the remaining tests, premature substrate failure prevented completion of this window, so the results could not be evaluated. Microscopy confirmed distinct interlocking morphologies across polymers, supporting the observed differences in failure behavior between peel and normal separation. Overall, the results indicate that perpendicular dolly pull-off testing is a practical and reproducible alternative for quantifying adhesion across a wider range of printed-on-textile bonding conditions.Keywords
Funding Information
- European Union’s Horizon Europe Programme (101132596)
This publication has 11 references indexed in Scilit:
- 3D Printing onto Textiles: A Systematic Analysis of the Adhesion Studies3D Printing and Additive Manufacturing, 2024
- Adhesion and Stab-resistant Properties of FDM-printed Polymer/Textile CompositesTekstilec, 2023
- Slit tear resistance of leather used in upholstery manufacturingIndustria Textila, 2023
- The Influence of the Structure of Cotton Fabrics on the Adhesion of Conductive Polymer Printed with 3D Printing TechnologyPolymers, 2023
- Adhesion Studies during Generative Hybridization of Textile-Reinforced Thermoplastic Composites via Additive ManufacturingMaterials, 2021
- 3D printed stretchable smart fibers and textiles for self-powered e-skinNano Energy, 2021
- 3D-printing on textiles – an investigation on adhesion properties of the produced composite materialsJournal of Polymer Research, 2021
- Development and testing of material extrusion additive manufactured polymer–textile compositesFashion and Textiles, 2021
- Adhesion of 3D printing polymers on textile fabrics for garment productionIOP Conference Series: Materials Science and Engineering, 2018
- Effect of knit and print parameters on peel strength of hybrid 3-D printed textilesJournal of Textiles and Fibrous Materials, 2018