Experimental Investigation of the Low Pass Filtering Effect of a Hydrostatic Bearing
Authors:
- 1 April 2014
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
Gears are used in numerous applications where mechanical power needs to be transmitted as in the powertrain of cars, buses and other vehicles. These gears can potentially be a significant source of high-frequency vibration and radiated noise in a vehicle, which can be both harmful and objectionable to any listeners in the vicinity. A proposed approach to addressing the gear mesh-frequency vibrations is to utilize the low pass filtering effect of a hydrostatic bearing in a gear mesh-frequency noise mitigation system. This paper describes an experimental investigation of the low pass filtering effect of a hydrostatic bearing using an experimental setup involving a widely available materials testing machine. By using the materials testing machine, appropriately sized hydrostatic bearing and externally pressurized fluid supply system, empirical data was collected that allowed the frequency response of the hydrostatic bearing to be determined. The frequency response of the hydrostatic bearing clearly shows a low pass filtering effect on the applied dynamic loads. Furthermore, changes to various system parameters had no effect on the frequency responses except at high driving frequency values. The observed low pass filtering effect of the hydrostatic bearing is potentially of great significance in any proposed gear mesh-frequency noise mitigation system since it prevents the mesh-frequency vibratory energy from being transmitted. Additionally, the experimental setup used provides a relatively simple setup for further studies on the dynamic behavior of the hydrostatic bearing.Keywords
This publication has 11 references indexed in Scilit:
- Nonlinear Dynamic Behavior of a Rigid Rotor Supported by Hydrostatic Squeeze Film DampersJournal of Tribology, 2008
- Squeeze Film Damper With a Mechanical End Seal: Experimental Force Coefficients Derived From Circular Centered OrbitsJournal of Engineering for Gas Turbines and Power, 2008
- An electrorheological hydrostatic journal bearing for controlling rotor vibrationComputers & Structures, 2008
- Nonlinear Identification of Mechanical Parameters in a Squeeze Film Damper With Integral Mechanical Seal2008
- Gear Noise and Vibration Prediction and Control Methods2007
- Optimized tooth profile based on identified gear dynamic modelMechanism and Machine Theory, 2007
- Reduction of noise of loaded and unloaded misaligned gear drivesComputer Methods in Applied Mechanics and Engineering, 2006
- Computerized Developments in Design, Generation, Simulation of Meshing, and Stress Analysis of Gear DrivesMeccanica, 2005
- Gear Geometry and Applied Theory2004
- Computerized Design and Generation of Low-Noise Helical Gears with Modified Surface TopologyJournal of Mechanical Design, 1995