Influence of Toothed Rail Parameters on Impact Vibration Meshing of Mountainous Self-Propelled Electric Monorail Transporter
Open Access
Abstract
In order to reduce the vibration of mountain self-propelled electric monorail transporters (MSEMT) caused by the impact of the meshing of roller gear with toothed rail (MRGTR), and to improve the stability and safety of monorail transporters, this paper theoretically analyzed the MRGTR mechanism of toothed monorail transporters as well as established the MSEMT displacement model and its instantaneous velocity model. The vibration signals of MSEMT with four different parameters of toothed rail were collected by the acceleration sensor and signal acquisition system. The signals were analyzed by the Hilbert envelope demodulation method to investigate the influence of toothed rail parameters on meshing impact vibration. Moreover, taking the vibration acceleration amplitude of MSEMT and the vibration attenuation time of meshing impact as evaluation indexes, a test based on the three-factor and two-level orthogonal test was engaged with factors of toothed rail pressure angle, the ratio of L—the chord length of two adjacent roller centers of a roller gear—and rack pitch p (wheel-tooth ratio) and the load mass of the MSEMT. It showed that the impact of MRGTR was the main excitation source of the vibration of MSEMT. The pressure angle and wheel-tooth ratio both have a significant impact on the smooth operation of MSEMT, the latter to a greater extent. So did the interaction between wheel-tooth ratio and load mass. The amplitude of the characteristic frequency of the MSEMT decreased with the growth of the pressure angle. When the wheel-tooth ratio was cosα, the number of the characteristic frequency was less than that when it was 1, and the amplitude became smaller too. When the pressure angle was 15, the amplitude of vibration acceleration characteristic frequency decreased as a consequence of load mass increasing. At the pressure angle of 25, the amplitude of characteristic frequency decreased with the increase of load mass if the wheel-tooth ratio was 1, and the opposite result occurs in the case when the wheel-tooth ratio was cosα. This paper provides a theoretical basis and reference for improving the impact vibration of MRGTR and optimizing the design of the toothed rail.Keywords
Funding Information
- Special Fund of Modern Technology System of Agricultural Industry (CARS-26)
- National Natural Science Foundation of China (61601189 and 31971797)
- Science and Technology Program of Guangzhou (201803020037)
- Key Realm R&D Program of Guangdong Province (2019B020223001)
This publication has 19 references indexed in Scilit:
- Reduction of Maximum Torque of Driving Shafts Concurrently Driven by Rubber V-belt for Monorail Traveling on Worn Rack Rail for Construction UsesInternational Journal of Materials, Mechanics and Manufacturing, 2017
- Control System for the Mountainous Orchard Electric-Drive Monorail TransporterApplied Mechanics and Materials, 2015
- Modeling and Kinematics Simulation of Shearer’s Travelling Mechanism Based on Virtual Prototyping TechnologyAdvanced Materials Research, 2013
- Nonlinear Dynamic Analysis of Helical Gear Considering Meshing ImpactApplied Mechanics and Materials, 2012
- S-shaped Multipurpose Monorail for Hillside OrchardsJapan Agricultural Research Quarterly: JARQ, 2007
- Safety of the tram car for slopes examined by stress analysis of the ground structureJournal of Forest Research, 2006
- New technologies and systems for high quality citrus fruit production, labor-saving and orchard construction in mountain areas of JapanJournal of Mountain Science, 2005
- Fundamental Analysis of Linear Type Trochoidal Gear. (2nd Report). Motion Principle for Roller Rack Type Trochoidal Gear.Journal of the Japan Society for Precision Engineering, 1999
- Research on the Trochoidal Gears (2nd Report)Journal of the Japan Society for Precision Engineering, 1995
- Research on the Trochoidal Gears (1st Report)Journal of the Japan Society for Precision Engineering, 1994