Postoperative Control of Technological Parameters of the Ion Implantation Process by the Method of Capacitance–Voltage Characteristics
- 1 April 2023
- journal article
- research article
- Published by Pleiades Publishing Ltd in Inorganic Materials: Applied Research
- Vol. 14 (2) , 587-590
Abstract
Experimental samples of single-crystal silicon with hole conductivity doped with boron (KDB-12) and with electronic conductivity doped with phosphorus (KEF-4.5) were studied using the C–V method of postoperative control. On the original KEF-4.5 and KDB-12 wafers, a dielectric layer of silicon dioxide SiO2 was grown. Next, the near-surface layer was doped with phosphorus or boron by ion implantation with the type of conductivity corresponding to the substrate. Postoperative control of the dose of impurity atoms embedded by ion implantation was carried out according to capacitance–voltage characteristics. The impurity distribution profiles for the same sample obtained at different points, as well as for different samples with the same implanted dose, differed slightly. The calculation of the dose of implanted ions and the relative error showed a high accuracy of control of the ion implantation process by measuring the capacitance–voltage characteristics. The relative measurement error when compared with the given dose did not exceed 10%. An error greater than 5% was observed for samples with an implanted ion dose close to the limiting dose detected by this method.Keywords
This publication has 9 references indexed in Scilit:
- Research on chip thinning technology2020
- Investigation of interference on photodetector CCD by lasers with different wavelengthsOptik, 2020
- Open-Source Automated Mapping Four-Point ProbeMaterials, 2017
- ECV investigation of ion-implanted photosensitive silicon structures for backside illuminated CCDsJournal of Physics: Conference Series, 2016
- Dopant Activation and Profile Determination with an Elastic Material Probe (EM-Probe)AIP Conference Proceedings, 2007
- Micro-Scale Sheet Resistance Measurements on Ultra Shallow Junctions2006
- Ion implant process monitoring with a dynamic surface photo-charge technique2004
- Recent progress and insights in two-dimensional carrier profiling using scanning spreading resistance microscopyAIP Conference Proceedings, 2003
- Some aspects of dose measurement for accurate ion implantation1977