Effects of salt concentration on top wall bubble injection in a turbulent channel flow: Bubble dynamics and wall drag reduction
Preprint
- 13 November 2023
- preprint
- Published by Springer Nature in Research Square
Abstract
Most applications related to bubble drag reduction (BDR) occur in contaminated environments where the presence of different surface active agents modify bubble coalescence and hence, affect flow drag. Although there have been studies on bubble drag modifications with salt/surfactant, the effects of systematic variation in salt/surfactant concentration on bubble dynamics and drag remain relatively unexplored. Driven by this motivation, in the present work, we experimentally investigate the effects of salt concentration on the bubble dynamics and drag modification in a fully developed horizontal turbulent channel flow for top wall bubble injection, over a wide range of salt concentrations (0< M <0.08, moles/liter), channel Reynolds number (22,500< Re <65,000), and injected bubble void fraction (0< α <0.16). The injected bubbles interact with the flow in the turbulent channel and as they move downstream reach an equilibrium state between the bubbly phase and the fully developed carrier phase that persists further downstream. The equilibrium state of the bubble dynamics is captured by high-speed visualizations and the corresponding drag is obtained from stream-wise pressure drop measurements within the channel. Increasing salt concentration levels is seen to lead to reduction in bubble coalescence and consequently in bubble size that modifies bubble deformability, migration, and distribution near the top wall, with the changes being dependent on the Re and α values. At low Re ≈ 22, 500, the addition of salt leads to a dramatic reduction in bubble sizes (∼ 100 microns) from the very large coalesced bubbles (∼ cm) seen in the no-salt cases, with consequent changes in the bubble dynamics and increased drag (up to 70%). The reduction in bubble sizes with salt addition leads to an increase in drag with salt concentration, which saturates beyond a critical salt concentration (MCritical). With increasing Re, due to smaller time available for coalescence, the bubbles are relatively small even in the absence of salt and hence, the bubble dynamics is found to be less susceptible to modifications by the addition of salt, unlike at low Re, and hence, results in a smaller increase in drag and a lower MCritical. At the largest Re of about 65,000, both the bubble dynamics and drag are found to be very similar in both the no-salt and salt cases indicating that MCritical ≈ 0. Our observations suggest that at low Re, the experiments in typical laboratory freshwater conditions will not predict the bubble dynamics aspects and flow modifications in contaminated environments, while it can be a good indicator at large Re. The present results can thus help deepen our understanding on bubbly flow applications in contaminated environments, such as those that occur in bubble induced drag reductions in ships and pipelines.Keywords
All Related Versions
- Version 1, 2023-11-13, Research Square
- Published version: Experiments in Fluids, 65 (3), 1.
This publication has 54 references indexed in Scilit:
- Effect of bubble distribution on wall drag in turbulent channel flowExperiments in Fluids, 2019
- Frictional drag reduction by bubble injectionExperiments in Fluids, 2014
- Time-resolved two-dimensional X-ray densitometry of a two-phase flow downstream of a ventilated cavityExperiments in Fluids, 2013
- Image analysis applied to study on frictional-drag reduction by electrolytic microbubbles in a turbulent channel flowExperiments in Fluids, 2010
- Influence of bubble size on micro-bubble drag reductionExperiments in Fluids, 2006
- Turbulent shear stress profiles in a bubbly channel flow assessed by particle tracking velocimetryExperiments in Fluids, 2006
- Flow structure of microbubble-laden turbulent channel flow measured by PIV combined with the shadow image techniqueExperiments in Fluids, 2005
- Bubble-size distributions produced by wall injection of air into flowing freshwater, saltwater and surfactant solutionsExperiments in Fluids, 2004
- Effect of microbubbles on the structure of turbulence in a turbulent boundary layerJournal of Marine Science and Technology, 1999
- Reduction of skin friction by microbubbles and its relation with near-wall bubble concentration in a channelJournal of Marine Science and Technology, 1996