Thermal Performance and Flow Visualization of a Planar Heat-Pipe Leading Edge
- 1 May 2019
- journal article
- research article
- Published by American Institute of Aeronautics and Astronautics (AIAA) in Journal of Spacecraft and Rockets
- Vol. 56 (3) , 771-779
Abstract
The sharp leading edges of a hypersonic vehicle are promising for the enhancement of its aerodynamic performance. However, they need a cooling mechanism because they are exposed to extremely high heat flux during reentry or hypersonic cruise, which easily heats up the surface materials beyond their temperature limits. This study explores the concept of a leading edge with planar heat-pipe cooling for which the whole inner surfaces are directly covered with a capillary wick. Its isothermal characteristic and simple configuration can provide robustness; however, due to the uniqueness of the planar type, the thermofluid characteristics should be investigated. Therefore, two kinds of heating tests (the inside visualization test and high-temperature test) were conducted using water as a working fluid. The gravity effects were surveyed, changing the test article attitude. The results showed that the planar concept worked as expected; no large temperature distribution was observed along both the chord and span directions, even in a nose-up attitude or a top heat configuration; the heat transfer performance was improved in nose-down attitude. During the heat-pipe operation, a heat transfer coefficient approximately 100 times higher than that of an evacuated operation was obtained. Visualizing inside the test article revealed that the screen mesh wick was properly covered with condensed water and that typical bubble formations of nucleate boiling were observed around the tip in some cases.Keywords
This publication has 7 references indexed in Scilit:
- Unit Operations in Environmental Engineering2017
- Two Phase Thermal Protection of the Hypersonic Leading Edge2016
- Thermomechanical coupling analysis of heat-pipe-cooled leading edge thermal protection structure with thermal contact resistanceProcedia Engineering, 2012
- Feasibility of Metallic Structural Heat Pipes as Sharp Leading Edges for Hypersonic VehiclesJournal of Applied Mechanics, 2009
- Ceramic Matrix Composite (CMC) Thermal Protection Systems (TPS) and Hot Structures for Hypersonic Vehicles2008
- Thermal Shielding of a Re-Entry Vehicle by UHTC Materials2005
- Heat pipe applications for the space shuttle1972