High-Brightness 980-nm Tapered Laser— Optimization of the Laser Rear Facet
- 12 January 2010
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 22 (5) , 341-343
Abstract
We present experimental results on a gain-guided tapered diode laser with rear facet coating variation from 98% down to 5% reflectivity. We show that in comparison to the common high reflection coating, a lower back facet reflectivity is suitable to suppress the propagation of modes outside of the ridge waveguide and the tapered section by keeping the output power at nearly the same level. Therefore, we can improve the spatial as well as the spectral beam quality.Keywords
This publication has 6 references indexed in Scilit:
- Tapered Diode Laser With Reverse Bias Absorber SectionIEEE Photonics Technology Letters, 2009
- Design strategies to increase the brightness of gain guided tapered lasersOptical and Quantum Electronics, 2008
- Fundamental-Lateral Mode Stabilized High-Power Ridge-Waveguide Lasers With a Low Beam DivergenceIEEE Photonics Technology Letters, 2008
- High-power high-brightness tapered diode lasers and amplifiers2005
- How to launch 1 W into single-mode fiber from a single 1.48-μm flared resonatorIEEE Journal of Selected Topics in Quantum Electronics, 2001
- High-power, strained-layer amplifiers and lasers with tapered gain regionsIEEE Photonics Technology Letters, 1993