Porous hydroxyapatite‐bioactive glass hybrid scaffolds fabricated via ceramic honeycomb extrusion
- 24 February 2018
- journal article
- research article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 101 (8) , 3541-3556
Abstract
The successful fabrication of hydroxyapatite‐bioactive glass scaffolds using honeycomb extrusion is presented herein. Hydroxyapatite was combined with either 10 wt% stoichiometric Bioglass ® ( BG 1), calcium‐excess Bioglass ® ( BG 2) or canasite ( CAN ). For all composite materials, glass‐induced partial phase transformation of the HA into the mechanically weaker β‐tricalcium phosphate ( TCP ) occurred but XRD data demonstrated that BG 2 exhibited a lower volume fraction of TCP than BG 1. Consequently, the maximum compressive strength observed for BG 1 and BG 2 were 30.3 ± 3.9 and 56.7 ± 6.9 MPa, respectively, for specimens sintered at 1300°C. CAN scaffolds, in contrast, collapsed when handled when sintered below 1300°C, and thus failed. The microstructure illustrated a morphology similar to that of BG 1 sintered at 1200°C, and hence a comparable compressive strength (11.4 ± 3.1 MPa). The results highlight the great potential offered by honeycomb extrusion for fabricating high‐strength porous scaffolds. The compressive strengths exceed that of commercial scaffolds, and biological tests revealed an increase in cell viability over 7 days for all hybrid scaffolds. Thus it is expected that the incorporation of 10 wt% bioactive glass will provide the added advantage of enhanced bioactivity in concert with improved mechanical stability.Keywords
Funding Information
- University of Sheffield
This publication has 74 references indexed in Scilit:
- On the structural, mechanical, and biodegradation properties of HA/β-TCP robocast scaffoldsJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2013
- Biomaterials & scaffolds for tissue engineeringMaterials Today, 2011
- Improvement of compressive strength of porous hydroxyapatite scaffolds by adding polystyrene to camphene-based slurriesMaterials Letters, 2009
- Bone ingrowth in macroporous Bonelike® for orthopaedic applicationsActa Biomaterialia, 2008
- Improvement in Biocompatibility of Fluoridated Apatite with Addition of Resorbable GlassJournal of the American Ceramic Society, 2006
- Porosity of 3D biomaterial scaffolds and osteogenesisBiomaterials, 2005
- Comparison of osteoblast responses to hydroxyapatite and hydroxyapatite/soluble calcium phosphate compositesJournal of Biomedical Materials Research Part A, 2004
- Frozen cancellous bone allografts: positive cultures of implanted grafts in posterior fusions of the spineEuropean Spine Journal, 2004
- Mechanical characterisation of porous glass reinforced hydroxyapatite ceramics: Bonelike®Materials Research, 2003
- Fabrication of Macrochannelled‐Hydroxyapatite Bioceramic by a Coextrusion ProcessJournal of the American Ceramic Society, 2002