Increasing adhesive bonding of carbon fiber reinforced thermoplastic matrix by laser surface treatment
- 25 April 2017
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 57 (7) , 685-692
Abstract
In this study, laser surface treatment of CFRP made of PPS thermoplastic matrix by means of Q‐switched Yb:YAG fiber laser is investigated with the aim to improve CFRP adhesive bonding. Two set of experimental tests were developed. In the first, laser treatments were executed fixing the average power (Pa) and changing: the pulse power, the scanning speed, the hatch distance, and the scanning strategy. These tests were performed to individuate the laser‐material interaction mechanisms and the process window. The treated surfaces were investigated using optical microscopy. It was found that the treatment is able to remove the outer layer of the matrix up to the exposure of underlying reinforcement. However, depending to the released energy, incomplete cleaning or excessive damage may occur. Then, the operating window was experimentally determined. In the second experimental tests, single lap shear tests were performed on samples treated under the most promising process conditions, to verify the laser treatment effectiveness. It was found that the laser treatment, compared to the untreated samples, is able to increase the apparent shear strength up to three times. POLYM. ENG. SCI., 57:685–692, 2017. © 2017 Society of Plastics EngineersKeywords
This publication has 42 references indexed in Scilit:
- Influence of plasma surface treatment on bond strength behaviour of an adhesively bonded aluminium-epoxy systemInternational Journal of Adhesion and Adhesives, 2010
- AISI 304 stainless steel marking by a Q-switched diode pumped Nd:YAG laserJournal of Materials Processing Technology, 2010
- Modelling of Fluidized Bed Degreasing (FBD) process by ANNsInternational Journal of Surface Science and Engineering, 2008
- Influence of low-pressure plasma treatment on adhesive bonding between polybutylene terephthalat (PBT) and aluminumInternational Journal of Adhesion and Adhesives, 2005
- Analysis and prediction of laser cutting parameters of fibre reinforced plastics (FRP) composite materialsInternational Journal of Machine Tools and Manufacture, 2002
- Microstructure Characterization of Laser Treated SurfacesThe Journal of Adhesion, 2001
- Plasma treatments of polymeric materials and Al alloy for adhesive bondingJournal of Materials Processing Technology, 1997
- Further studies into the effectiveness of CO2-laser treatment of metals for adhesive bondingInternational Journal of Adhesion and Adhesives, 1997
- Improvement of adhesive bonding in aluminium alloys using a laser surface texturing processJournal of Materials Processing Technology, 1997
- Electrode discharge for plasma surface treatment of polymeric materialsJournal of Materials Processing Technology, 1996